G7 Back Glass for L-G G7 ThinQ Waterproof Battery Back Cover+Camera Lens Cover/OEM Rear Panel Back Glass Replacement with G7 ThinQ G710ULM G710VMX G710PM LMG710TM/VM All Version (Red)

Looks and feels really nice, it sticks pretty hard. So make sure the replacenent is perfectly aligned. I made sure the bottom side fit very well but left a little gap on the top. Tried to realign but it was stock really good already and did not want to break the glass trying again. I used some heat from a hair dryer to pull out the firger print and other staff from the old glass. Placing everything together was easy. Does not come with instructions but the new one looks exactly the same as the old one so it was not hard to do it by myself.

Lol the reader and flash have to be transferred from the old unit... didnt realize it so had to remove it quickly before it stuck..the reader came right out but of course the flash broke. Such is life. Product is great quality and exactly as described. Awesome seller fast shipping painless transaction very easy install

It did not have a couple of the mesh covers that I'm not sure the purpose of, but it installed well and the adhesive held tight. It's been a week with no issues.

It seems like good quality and the color matches, but mine did not have the "G7 ThinQ" print on the back. Also there is some minor discoloration in 1 spot. I use a case so that stuff isn't terribly important.

The cover looks and fits exactly as oem.Take your time, and make sure to move the ir lens and flash diffuser from the old back to the new one. Use a heat gun on the underside of the stock glass to soften the adhesive, and work them off with an exacto knife. Use a little B-7000 glue to resecure them to the new back. Also, B-7000 works perfectly to secure the fingerprint scanner, and will also maintain the waterproofing of the phone. Also, take the time to remove ALL of the old adhesive from the phone. This will make sure that the new adhesive sticks properly. Once the new back is on, heat the edges and the adhesive areas at the bottom third of the phone, and beside the camera lens with a heat gun to help the new adhesive bond. Carefully squeeze/press around the edges to bond the new adhesive before it cools. The back on the Raspberry Rose (red) matches the OEM back exactly, minus the IMEI number, obviously.

Got what I ordered in good condition

Purchased to replace the broken back on my phone, and personalize slightly by replacing the factory grey it had with black. Kit came with more tools than needed, I only used the two plastic pry tools. You will have to pay attention to the small parts before you toss your old back glass, you MUST remove and transfer the fingerprint sensor, IR lens, and flash lens to the new back glass. There will be a small, camera shaped piece of double sided adhesive. You MUST clean the double sided adhesive from the original sensor and replace it.

Lenses come installed, but no fingerprint reader. One has to remove the connector plate from its support in the old back, because the support is glued on the new backglass. The provided seal does not glue well. I used heat after applying, and put the phone under a 7 inch enciclopedia for pressure. But it came loose anyway.