Edge Supply Red Oak 7/8 inch X 50 ft Roll of Plywood Edge Banding – Pre glued Real Wood Veneer Edging – Flexible Veneer Edging, Easy Application Iron-on Edge Banding for Furniture Restoration

We use this in our cabinet shop and find it to be just as good as the non-glued veneer. It is too thin and the glue is all wrong for use in our antique restoration shop but if you are buying this for new-made furniture it is perfectly adequate. Be sure you set your iron hot enough and follow the application with masking tape to hold it firmly in place for a recommended 6 hour cure time before trimming, sanding and finishing. For best finishing results I recommend that you buy cork blocks and rub the veneer firmly once installed and cured to burnish the surface to get the truest most consistent finish and coloration. If you skip this step the wood dyes and finishes will adhere and behave differently giving less than satisfying results. Overall this can be used for all new furniture applications as long as it is applied carefully, cured and grain blended. It’s an excellent product that I recommend for any pre-glued application. There’s a bit of a learning curve but you have lots of veneer on this roll! Practice on some scrap first.

The veneer is perfect - available in several shades and lengths - very helpful in my workroom.

Surprised at the quality for the price! Used for custom shelving and will use the whole roll. In comparison to the small rolls from Lowe’s it’s about equal quality so for the price this is an amazing deal and will be getting it again! Went on easily the glue seams to be a high quality product and took stain well. All in all more than happy!! Seen reviews about the splices and would say it has about the same per lineal foot compared to the Lowe’s product and at least with the darker stain I used it to as the noticeable and if you pay attention to your application you can avoid using the splice all together.

Have installed about 50’ of this material so far, with continuous runs up to 8’ long. Excellent quality edge banding, wood veneer layer is top notch with no visible splice joints, the glue layer backing is thicker then most other products I’ve worked with in the past. This edging forms nicely around radiused corners, conforming quite well with little effort. The adhesive holds really well as long as you make sure the edge of the material you are applying the banding to is clean and you apply pressure to the banding, right behind the iron, as you apply the banding. The Edgebanding trims well with a hand edge trimmer with no noticeable splitting or chipping.

Good glue, very happy with the purchase. Quality product. Highly recommended.

I build things, usually shelf units, out of oak plywood from the local home center. Of course, you need to do something with the edges. This product is the perfect width for 3/4 inch plywood, so there's a minimum of trimming needed. It's easy to apply, with a hot iron, and blends well. The photo shows two-inch banding for the edge of my desk. The open drawer is made of oak plywood with edge banding applied. Some LIGHT sanding, stain, and polyurethane completes the job.

Foremost the good: You see no seems nor fingers. The only downfall of the product is the label they put on the outside of the roll, so you end up cutting off the first foot, because of the residue left on the outside layer of veneer.But great otherwise. More than worth the money

This is a great edge band easy to apply and except stains exceptionally well. There were no cracks in the edge banding in the center of edge band like I have seen on others that you have to cut out and ca not use. This whole roll was excellent and I will buy more. Plus the cost for this product is the best price I have seen around. So if you are looking for a premium edge band at a great price thus is it. I 100 percent recommend this product