• Smooth Result every time.
• Strong y s.
• Fast root generation.
• The roots were shown, up to 10 days faster, with 30% longer roots and up to 156% more roots than water alone to mist your cuttings use..

CLONEX MIST Clonex Mist is an established product developed especially to make cloning even more successful. Clonex Mist is easy to use giving … Consistent results every time Fast root generation Strong y s Clonex Mist has been independently trialled in New Zealand by Dr. Lynette Morgan of Suntec Laboratory on Ficus and Dianthus. The development of roots was shown to occur up to 10 days quicker, with 30% longer roots and up to 156% more roots than using water alone to mist your cuttings. CLONEX Mist is easy to use and generates quicker, more vigorous and y clones. For best results use with CLONEX Rooting Gel and Root Riot propagation cubes. All your cuttings benefit from housing them in a propagator with adjustable ventilation. Instructions for use – stem cuttings Choose a y with strong growing tips. If possible the growing tips can be sprayed with Clonex Mist once or twice in the week before cuttings are taken. Use a sharp clean blade, such as a scalpel, to make a diagonal cut in the stem – just below a leaf node. Use sharp scissors to trim off some of the larger leaves, leaving two or three on the cutting. If Clonex Rooting Gel is available then dip the cutting straight into the gel. Immediately insert cutting into the Root Riot cube, which should be moistened before use. Spray the new cuttings with Clonex Mist and place in a propagator. The lid should be down and the vents closed. After 2-3 days spray the cuttings with Clonex Mist again and open the vents slightly. Check the new roots after a few days – continue mist until the is established following potting up. If ing in soil, place soil carefully around the roots to avoid damaging them TOP TIP: Repeat this misting every 2-3 days or when cuttings look dry. Open vents wider every day. A slight condensation inside the propagator indicates adequate humidity.