The GE WH16X10186 is a genuine OEM Spinner Support Assembly for Washers that supports and spins the spin basket. The WH16X10186 is an original GE Spinner Support Assembly that is manufactured to exact specifications with high quality materials. It is recommended that either the manufacturer of your appliance or the service manual for your appliance be referenced prior to selecting a part for replacment to insure that the correct part is purchased.
R**S
Works fine plus TIPS for first time installers not found on YouTube.
I ordered this and they sent be some GE gas stove grills. I requested a replacement and returned the grills. They cancelled that order so I had to reorder separately. TIPS-1) YouTube appliance repairmen show the TOTAL washer tub being installed. I did not find one for just this Support Assembly. They are very helpful to show the disassembly but not this specifically this part. AND you DO NOT need to ORDER the associated WASHER TUB SEAL (WH08X24594) as this came with it attached. The front panel removal is by using a metal putty knife about 3" from the edge- just push it STRAIGHT IN to release the clips and pull the panel forward. 2) Once the tub is out, careful turning on it's side since there are plastic tabs that snap onto the top ring piece. They break off easily. 3) I had sprayed the inside washer nut that is attached to the spindle with Nut Buster spray. The nut is REVERSE THREAD- so go get off, you need to turn it RIGHT. I could not get it off with channel locks, and ordered the SPANNER Wrench sold here. I could not break the nut with a rubber hammer as there is not much room inside the tub to generate force. I used a regular steel hammer and suppose as small sledge hammer would've been better. 4) Once that is off, and all the nuts are removed from the bottom assembly, along with the motor and transmission (that are used with this new assembly)- you can try to wiggle and pull the bad/old assembly out of the tub. If that doesn't work- put the entire tub on stands so it's off the ground and in a position that allows the assembly to fall freely to the ground. Use a 2X4 or other piece of lumber and place on top of the spindle and hit it with a hammer to allow the spindle and assembly to be freed from the tub and drop to the ground.I hope these help other first time DIY'ers to replace this part. Good luck.
J**L
Worked well, contained nut, washer and seal.
Picture did not show the nut or washer, but the product I received contained these parts. Plan on getting the proper wrench to remove the old hub nut.
K**1
Fits just fine
Product came just as expected with no issues, and it fit my model perfectly.
M**N
Worked perfectly!
Worked exactly as expected.
G**Z
Great price, availability n quality!
Works great super quiet! The old one sounded like a train in my house.
K**Y
Five Stars
Had to send back
D**S
Five Stars
Fit well in my GE
D**G
Worked perfectly
Worked just like OEM. It had fine threads, don't throw away your tub nut.
Trustpilot
4 days ago
2 months ago
