MOSTPLUS Engine Valve Cover with Gasket 13264JA00A 13270JA00A Compatible with 07-13 Nissan Altima Sentra SE-R 2.5L QR25DE

Very affordable for all the parts you’re getting. You’re getting a new valve cover. Valve cover gasket. Spark plug tube gaskets and a new pcv valve. Kind of a pain to install but well worth it in the end. Quality is basically the same as oem Nissan part. Just take your time while doing it and you’ll do just fine. While you’re in there minus we’ll change spark plugs and coil packs. Also you’ll want to buy a new pcv hose because chances are the original one is hard and brittle. My 2010 Altima has 245k on it and runs like a dream. Well worth it in my opinion

It lasted

I had 2 spark plugs that were fouled because the seal around the spark plug tube had gone bad. The simplest and most cost effective way to solve this was to purchase the MostPlus Valve cover and replace it. There are plenty of good YT videos to walk you through the replacement. I now have a leak free Altima that is running like a champ. This Valve cover was one of many things I replaced on the altima. I can assure you that the quality and fit of this cover was perfect. I will end with one special note. It was VERY easy to cross thread the bolts that hold the valve cover down. Make sure you keep the bolts perfectly vertical when hand screwing them in. If they get cross threaded then 1) You will see that the bolt is at a very slight angle (not 90°) and 2) You will most likely break the bolt off when you try to tighten it down. If any of the bolts are cross threaded they will not properly tighten down the valve cover and you will be leaking alot of oil. This is not a difficult job, just go slow and pay attention if this is your fist time doing something like this.

This product is affordable and works well. Dumb design by OEM manufacturer where entire cover needs to be replaced for leaking seals.

Fits well. But the threaded inserts to secure the coils spin out of the cover very easily. For the price I can get by with it, but be extremely careful when running down the coil fastening bolts

Fit perfectly on my 2007 Nissan Altima 😎

the parts fits great on my nissan altima 2008 and relatively easy to put in the cover itself the hardest part is actually getting wires out of the way and jacking up the car when you take engine mounts off. Also may smoke for a bit after installation so just make sure gasket is on straight and clean any residue oil on your engine

The cover comes with everything you need to repair oil leaks caused by faulty gaskets.