Spray Gun w/Pressure Cup 1100ml 4-6bar 1/4" Cavity Gun w/Hoses Spray Gun w/Hook and Round Nozzle

I bought this for spraying of thick underseals and also injecting of waxoil into car body cavities. As a sprayer, it certainly spits out thick paint products under high pressure but be warned it makes quite a mess with over-splay and the finish is more of a flaked look than normal paint finish. The image shows results with white Tetrosyl . But it excels when used with Waxoil. the attachments can be pushed through tiny holes (even a captive nut after a bolt is removed. The spray pattern is even and 360 degrees so you start at the maximum depth and withdraw slowly while depressing the trigger for an even coating on insides of sills and other body cavities.This spray gun is exactly the same as a more expensive well-known branded version, so excellent value. I recommend it.

Realy nicely made,heavy pressure bottle good review on utube

A seal packed up causing an air leak after using it a couple of times but I replaced it with an O ring I had to hand and now all good.Also the cavity probe spray attachment is way too flimsy to feed into box sections/body cavities so I covered it in glued filled heat shrink tubing which gave it just the right combination of flex and rigidity. Without those two niggles I’d have given it 5 stars as it now works perfectly for spraying Corrosion Block and ACF50 oil based products. I’ve not tried it with any waxed based products as I no longer use them but I’ve no doubt it would handle them easily.

This was used to spray wax oil underneath my car and was easy to use. Did the job.

I dont do reviews usually. Tried a few sprayers over the years, I could pick fault (lack of adjustability to alter pattern/ amount of product used/ the extension tubes a bit soft, Euro adaptor ) but all in this was decent, it's got a pressurised pot, decent throw of product and with a little patience the extensions are ok too.Ran it about 40-50 PSI, 5 bar using Bilt Hamber UC and UB both thinned with 10pc white spirit and kept in hot water.Did a decent job. I'd buy it again and hope mine lasts a long time as it was money well spent

Very strong and well made,

Disappointed (unless I am missing a part or something). Gun etc OK - but spray pattern is terrible - globs and glupes from end, irregular, massive volume changes making wasteful. Been using ACF50 - not the cheapest thing to waste! Have tried thinning but to no avail. NOT RECOMMENDED in my opinion.

Very well made spray gun. Pity delivery was over 10 days.

Nickel

ben zeer tevreden, zeer gebruiksvriendelijk met accessoires, werkt perfect

Kanon 🤘🏻

La pieza es chatarra, gotea por todas partes y el sello de la cavidad tiene fugas.

Questa pistola a spruzzo è molto valida specialmente se si vuole trattare di scatolati e lamierati delle automobili.