Pyle 2 Channel Car Stereo Amplifier- 1400W Dual Channel Bridgeable High Power MOSFET Audio Sound Auto Small Speaker Amp w/ Crossover, Bass Boost Control, Gold Plated RCA Input Output, Black - PLA2200

I have a 2oo watt clarion head unit. Its the base model, but still 50x4. I use this amp with 2 12's Fosgate Punch 1's. I had an 800 watt amp and always had the level maxed and the frequency punchy the whole way down. My head unit also has a sub volume which was always maxed. I actually use my subs to bring in the low end in my car and use the other 4 speakers (kenwood 3 ways) for mids and highs. I bought this Pyle amp with Cadence Acoustic wires. I had the bass boost on the amp on HOWEVER I only have the level half way and the frequency is set about a quarter high. This is perfect because I am rolling my head unit vol. half way and the bass gain down. Bottom line is this amp is only pushing half what it can, and it is supplying all my low end. Very good punch from low frequencies but also sensitive enough to fill out the bottom end with a wide range. I am actually picking up what the bass player is playing, along with filling out low end frequencies on the drums and nice full punch on the kick. I am so stoked to have picked this amp up so cheap and so stoked that it sounds so awesome. I have had many different set ups in my car over the years and for the price this amp is perfect. Like I said, "Only half the power it can do and more than I need." Pick it up, set it up right, and you won't be dissapointed. Of course if you are running an amp to your other speakers and really pushing out wattage you will need something high end. This has no problems shaking the rearview!

Works great. I have it on 2 10” subs. Way more power than needed.

Sounds great self explanatory directions good value for the money

Nice addition, old amp finally quit, this brought back a sound that fit the bill

After I finally got around to having this amp installed, I was pleased as punch to having a little bass in my trunk. It sounded decent, for the price, and filled out the low end nicely. Unfortunately, the success was short-lived. After the first day (and literally less than 4 hours of use) the amp stopped working. I checked to see what had happened and the two 10-amp fuses on the amp were both blown. Perhaps I had the levels turned up too high, so I can claim responsibility for blowing the fuses (even though I'd think the built-in protection circuit would trip before the fuses blew - which it didn't). [Note: I'm using this amp with the Pyle 12" 600W sub, which you'd think would be a tested match]. So, I replaced the two fuses and expected to be back to normal. WRONG. Now when I turn on my radio with the volume on the lowest setting, the amp turns on for a second and then immediately goes into "protection mode" (the green light turns red). This means no sound from the amp. All of my other fuses are in-tact, but for some reason, the amp just won't stay out of protected mode. Given that it's broken so quickly, I'd say stay away.

What else do you need to know? It's not something that's going to push your subs, it's not going to make everyone around you feel what you're listening to so if that's what you're aiming for I'm going to detour you somewhere else and I apologize... Mine worked for over 2.5 years... Why did it stop working? I helped someone jump their car, I hooked up my end, they didn't hook up theirs right and the surge fried the amp... What you need to know: This is a good amp, nice quality, and easy to install. It lasted for a really long time for me, and would still be going if people weren't retarded, but hey, mistakes happen right? I got my use out of it, and I hope you will too... I used this Amp with the Dual Bandpass 10' subs with the neon light rings around them. The case is gray, and the middle has a clear panel, with four silver plated air holes on each corner. they were 1k watt subs, so this didn't push but 700 to each (though on my review I wrote 500 because I never really turned this amp all the way up). This amp does get hot, please be aware of this, but it's a good product. Thanks for readying and good luck to you all!

Excelente producto cumple con todas las espetativas.

I liked the price which is why I'm sure ALOT of use bought this amp, When the amp hits it hits hard , but even with the gain turned down low and all the bass turned off at the deck , the amp will start to get hot after 4-5 songs and shut off to cool down, once it's cooled down your back to bass , that is until it gets hot again repeat process. I have the 1400x2 amp , on 2 fosgate 10s p3s The amp does not handle the base at all. I give it a 3 star because when it is cold it works great, it's price effective, however there is no longer car rides and enjoying your music loud with this amp

Excellent great looking amp, works perfectly and pumps out volume just how I like it, LOUD! Very happy with this purchase

Not sure that the item should have silver screws and a photocopied manual???

It was ok not happy that when you purchase this amp that if you are not satisfied you can not return it