aFe 46-10011 BladeRunner Intake Manifold

I installed it in about 45 minutes.It came with all required hardware and intake gaskets.It improved throttle response and put a smile on my face; so I would say it's a great buy and I would recommend it.My cold air intake and turbo back exhaust will be delivered next week, so I am sure it will flow even better when those are installed.

Looks great, works great, easy to install! Make sure you run some sandpaper on the inside to get burrs off from casting and drilling. Convenient ports for boost gauges, water meth or nitrous injection. I have cooler egt's spool comes a bit earlier but I'm modded so can't say results for a stock truck! I would buy again!

I had the plastic, CFM+ manifold but it melted. the AFE manifold is definately built better and seems to add a little power. Easy install, however the oil dipstick was hard to relocate. I recommend this product.

Good product to have on your truck. It will improve the trucks performance by having it breathe more efficient. Installation was quick and easy, you just have to take your time.

If I would have known then what I know now I would have not got it. do not notice any diff over stock

Easy install as described

Great product

So far so good, can't say much because I haven't installed it but I got it today and man it looks great. Packaging was very protective, all hardware included as advertised. You really won't see a difference in performance with this piece unless you have some decent mods already on your truck i.e. Performance tune, intake, full exhaust, injectors, etc. This piece alone will not do a whole lot until your truck is pushing more HP than stock. I will update after install.----UPDATE---- mind you, my truck is stock except for an AFE stage 2 intake. After installing the intake, mileage went from 16.5 highway to 18 highway. After a 20 minute install of the bladerunner elbow here's the results: 22.2 mpg @ 75mph -increase of 4.2 mpg-24 mpg @ 55mph -increase of 6mpg-