.30-06/25-06/.270 Laser Boresighter

I have one for each of my guns with scopes. They work great some people complaint about the laser light not being bright enough. I have never had that issue. It's very easy to do, just load the batteries put it in your gun like you do when you have real ammo. The laser comes on as soon as you load the batteries. Then you set your gun on a gun vise if you one. Next have a target setup at about 25 yards or more It's up to you, it is recommended to do 25 yards. Point at the target on the bulls eye with the laser then adjust your scope cross hairs so they come to a cross right on the bulls eye and the laser light. Then you just unload it from your gun and load real ammo, start shooting at your target and see if it's correct if not go back and do the laser again. It really works and it's so easy. I take mine with me anytime I go hunting or just target practice just in case my scope needs to be readjusted. I really recommend this and I got mine in two days. It's a very good product. You can't beat the price on Amazon, if you go to a hunting store you will pay double or more for the same thing. Last thing just make sure that you order the right caliber for your rifle or pistol.

I bought this to help sight in my 1974 Remington 700 BDL 30.06. With ammunition between $1.50- $4.00 dollars per round, I felt I could save money using this boresight even after seeing many reviews with only one star rated. An $18 range fee is the same as this boresight cost. I received the unit yesterday and immediately checked to see if the laser worked. It did. Be careful unpackaging because the batteries are very small even for a 30.06. I dropped one and had trouble locating it. The correct way to install the batteries is engraved on the side of the laser. There is paper in the battery chamber. I pulled the paper out but the laser wouldn’t turn on, so I left one battery in, put the paper in, then the other two batteries, and voila! Now I have a working laser. Remove one battery so the unit is off until you use it as it does not have an on and off switch. I printed out a bulls eye target out on 8 ½ x 11 paper. The diameter of the outer circle was nearly 7”. I measured out 100 yds exactly at my place and built a rest for my gun and looked through the chamber with the bolt out until I could see the paper through it, and waited for dusk. At dusk, I put the batteries together to turn on the laser, and then chambered it into the rifle. You have to wiggle it to get it in the chamber since it does not have a point like a live round would. Be gentle with it. After getting the laser into the chamber, I gently pushed the bolt forward until I could lock it down. Then I looked through my 3.5-10x power Nikon Monarch UCC 50mm scope and the laser was within view at 10x, and actually was on that paper! I adjusted my scope until the red dot was centered on the bulls eye. I was amazed that I could see the red dot at 100 yds and it covered only about 2” of that target. I was thrilled! I ejected the laser like a real bullet. Be careful to catch it. I put it back in and did another adjusting of my scope as it was off over 7” down and to the right. I repeated this procedure turning the laser about 45 degrees each time and adjusting. Finally, it seemed to be pretty true each time I turned it. As light became limited, I found out that the laser was illuminating the bullseye! I could not see the bullseye without the laser on! I am at this point now. I will do the same adjusting tomorrow night to see if I get the same results. Then I will venture to shoot a round to see if this matches up. That is the true test and I will post my final results.

ayuda.

I bought the 30-06 put it in barrel of a supposedly sided in rifle. It was about a foot and a half off. Adjusted the scope where it needed to be and sent one round through and it was dead nuts accurate. Very happy with my purchase!

Operates as intended.

Love the item….. but the battery life is trash. I don’t store the batteries in the item but in a container with the item and they are dead after 3 days…… batteries to expensive to keep buying to only last 3 days

I took a chance and tried this for 25-06 since it was cheaper than the Sightmark unit. I have SIghtmark laser bore sighters for 270WSM, and a few others cartridges and a Redfield unit for 308Win and 20Gauge. This unit works as good, or maybe even a bit better, as any of those so I can recommended it. Please be aware of the limitations of laser bore sighters and go on-line to understand how to best use them. They can help you boresight your rifle at 15 yds in bright daylight or at 40-60 yds in low-light (dusk) conditions. They won't really sight your rifle in adequately at 100 or 200 yds or beyond.

Not worth the buy! Bought this to aid in sighting a 30-06 and its not even powerful enough to be used as a cat toy. Bought new batteries and upon chambering the laser was not set inside the shell casing. Again, not worth the buy at all.

This will help get you on paper a lot faster/ cheaper than running a whole box of ammo through your rifle. Very happy! Only gripe is that you have to remove the batteries to turn it off.

Best thing ever! No more wasting shells! I have one for every rifle I own

Facile a utiliser, parcontre le laser n'éclaire pas bien par temps ensoleillé.

good accurate laser chambers and extracts easily makes quickscope setup

Tel qu’annoncé. Fonctionne très bien. M’a permis de zeroté ma 30.06 facilement.