KOWOOD Tongue and Groove Set

It is bery good product it’s sharp and everything that needs to be

Extremely happy with this product!!! 1/2 shuck. Ive put it through the Ringer learning how to make cabnite and drawers. Oil the bearings clean the bits ever couple of hours. Make sure if you adjust it to use leather gloves and tighten dowm the same way each time. Because that affects the adjustment aswell. Consistency is important Ive also adjusted the depth on the router table for 5/16 and used it instead of buying a dado blade for the 1/4 panel to slide in the bottom of the drawer boxes i made.

I am relatively new to woodworking, and I bought these router bits to build cabinets as a substitute for a table saw that I don’t have. I don’t have a router table either, so I used these in a handheld router. I made some pretty dangerous mistakes my first go around— so hope this helps. These bits are rated for a much lower RPM than the fixed-setting hand router I had, so trying to use them when they’re spinning at 26k rpm caused some crazy kick back and cut out. I wised up quickly and bought a variable speed router and brought it all the way back to 10k and they actually worked great. I made 6 cabinet door frames with these and by about the 4th frame the bits started to dull and I had to make my passes shallower and slower to minimize the cut out and the occasional kick back. For the price it was worth the purchase, but if I had any larger of a project I would’ve opted for something different. Probably not meant for a hand router but it worked in a pinch.

Bought a set for my dad as a gift. He has been using them in his shop and really likes them.

I bought 13 pressure treated 1"x6"x8ft boards and turned into a tongue and groove exterior ceiling for an area on a porch to mount a TV at my most recent job. The single female slot obviously cut easier than the double, still both cut very well. Going to want to use a strong full size router. My bosch colt router wasn't enough to cut it. However my large full size metabo and these bits ripped through no problem and helped me built a great job. Really impressed for the price. Extremely impressed I should say. The fit nice and tight. Perfect and exactly what I wanted. Over 100 ft on each and still super sharp.

They did the job but there was a lot of vibration from them. It took a toll on my router.

Great bits at a great price

I have only used the groove cutter, and it cut the groove in primed pine like butter! Flying thru my project with this awesome cutter. Only caveat is the cutter is overall diameter very wide. If using in a router table it may not clear the access hole. I have an old crappy table and old craftsman router. I had to adjust the router to full height to install the cutter. Then back down to the right height. Then remove the bit guard from the fence, which also would not clear. After that everything worked perfectly. So just be aware on clearances. Can’t beat the price and ease it has provided for my project. Bit is sharp, and is cutting a clean perfect 1/4 groove.

satisfait merci

It did the job for which i bought it for. Would buy from them again if needed.

Received a used product even though I bought new. No additional washers and they were covered in wood residue/ dust.