SKB 6U Roto Rack (1SKB-R6U)

Rack mount inside was high quality and came with mounting screws. The case locks tight and it seem ruggedized for most travel requirements. It has Front and Rear releases and it locks on removes very easily. Would highly recommend, terrific value for the money

Been using SKB for decades. Always great quality and they’ve got a great lifetime guarantee.

Awesome case. Bought for my Crown XLS1500 and a surge protector. Still has room to squeeze my mic system in underneath. The case is even large enough to fit my mixer in the back behind the amp for when traveling.

Works perfect for my Ham Radio Go Box. Lightweight, sturdy and does what I need it to for the mission at hand. I highly recommend this for your Ham Radio Go Box Needs. 73's

It's sturdy and works well to protect my gear, but damn is it a massive case! I've got a 2U QSC amp in it, and it weighs a ton. Most of the weight is the amp of course, but it's not super light when it's empty. I like it though. My rack rails are clean and were installed nicely. I wish I would've gotten something with wheels but that's my fault for not thinking ahead. My best advice: plan for the gear you have and buy the size and weight that will suit you best and protect your gear adequately. This beast barely fits in my car (a small car granted). Recommended for it's quality build.

The SKB cases are number one for drum protection. Solid and reliable.

Well designed. Gaskets on the covers. Strong recessed handles.Comes with rack screws! Washered screws are better quality than some I've used.

Its a solid case, looks really styling, keep in mind it is plastic and a little cheaper, Doesn't flex especially when full, but even partially it was doing great. Plenty of screws for me, One amp, sound processor, and power regulator takes most of what I have to "carry" around without looking like a total wuss. Could have had a nicer inside, but when its full its full and its done.Recommended.

No es lo que dicen vender, nada que ver con las fotos y descripción.

Perfect for the short depth rackmount chassis up to max 520mm without telescopic rails 450mm. To assembly rails it is necessary to milling up to 1.5mm both inside, but it works.

Niot as good as the old one's - Why is it manufactures take to changing perfectly good gear for stuff thats one half as good who knows?!!. The Plastic is as slippy as ice. The case is not as robust as the old type, the top sags so nothing will sit on it without sliding, even if you have two of these they don't fit together without sliding, stand a metal case on top and it will be on the floor in seconds. These slide around in the van, on a table, on a polished floor anywhere you put them down there are a real pain.

Great product

These are great racks and hold up really well over time, probably better than almost any other plastic rack case I've used. They're also pretty light for their size which makes them convenient for wireless racks, snake heads, or anything else that gets moved around a lot. The one caveat, and from talking to other techs it sounds like a known issue with these racks, is that the butterfly latches are slightly too loose when closed. If you throw these around and abuse them the butterfly latches can come undone in the truck, allowing the rack lids to fall off. Not a big issue, just don't put them in situations where they're likely to get handled overly roughly. For what you'd expect to put in a roto molded rack they're fine.