KEMIMOTO4 Pack UTV Pass Through Bezel, Harness Pass-Through Seat Bezel Insert Compatible with Polaris RZR XP1000 900 S XC General

The directions were good. There are a few you tube videos that also helped with the install. Definitely use a Dremel to cut the back of the seat. Using a sharp knife will not work. They said not to trim any foam on my model, however I found it necessary to do so for getting the bezels to marry.

These are great if you dont want to order seats with passthru for harnesses. Easy to install and has the templates so you know where to cut. Took me about 30 min to do

These inserts are the perfect addition to the stock RZR seats if you are planning on adding 4 point harnesses.Initially the installation seemed a bit intimidating because you essentially have to cut up your factory seats by cutting out some plastic and slicing the fabric. The first one you do will most likely have the most trial and error and time spent figuring out how to make things work and fit right.My suggestion to anyone who is planning on buying these or has already bought them is to invest in a Dremel with cutting discs. I did not have a Dremel and ended up doing the majority of my cutting with a angle grinder. Due to the size of the angle grinder blade I was not able to make specific precise cuts so I relied on a hand drill with grinding attachments to finish out some of the corners. Once you get the hang of it it is very easy and seats 2-4 were a breeze.Overall these inserts are much more cost effective than spending a lot of money on aftermarket seats that come with harness pass throughs from the factory.

Works but dosnt come with a lay out to see where to cut out ..had to figure it out on my own by doing my own layout ..looks good so far ..

A little hard to install the first one but after that, they were easy. Watch some on line videos before you start, there’s plenty of them online. I used a Dremel with a small cutoff wheel, a box cutter with some fresh blades, a long “click” knife, and a 1” hole saw. The trick with the hole saw was to shorten the pilot drill bit and drill easy.Fist one took 2 hours, second one 45 min and the last two took 15 min.

The product is decent. The back of the seat cut out is correct. The front cut is not. If you follow the front cut (figure H) your seat material and foam will be exposed.pic 2 At the top. It says cut 1" below the seam, " through the bead. DONT DO IT. Pic 2 is the result. The cut needs to be 2.5 inches from the seam or 2.5 inches down from your "z" in the rzr logo. If you don't believe me, before cutting push a screwdriver through your foam, at the ends of the pass through and mark it. Do not cut through the beads stitching. Just a small material slice will work. It's a little tough to stretch the material, but you wont be disappointed. Pic 1.and 3. Ive contacted kemimoto with the issue after destroying my seat. Happy trails. JT

Super awesome makes seats super comfortable

Everything you need to get the job done correctly. Easy to do with the great instructions