DTechFTDI USB to TTL Serial 3.3V Adapter Cable 6 Pin 0.1 inch Pitch Female Socket Header UART IC FT232RL Chip Windows 11 10 8 7 Linux (6ft, Black)

Was able to communicate with a Curtis 1206AC-5251 controller using this with FT-PROG and Curtis 1314-4402 software.

This is a pretty nice cable that is the equivalent of the FTDI USB to TTL cable. The one key difference being that there is a longer shank at the USB-A connector which houses the PCB with the components. I was able to modify this cable using a 0.1 mm thin wire to internally short RTS to CTS so that I can use the cable for a special hand-shaking application. I already bought two and plan to buy more in the future!

DTech FTDI USB TTL is working well with Windows 10 and 11.

Works with my Windows 10 machines without issues. 5 volt power output. 3.3 volt signals for direct connection to microcontrollers.

When used with Zadig (free to download) to install appropriate drivers, this is the only USB<->Serial adapter I recommend.

I liked the fact that the colored coded leads followed conventional assignments: RXD (yellow), TXD (orange), VCC (red) and GND (black). This made it easy for me to wire the module correctly to my computer.

Wired properly. Some I have bought on fleaBay were not.Needed this for an RC 2014 Z80 I built.Works like a charm. Not much else I can say.

I used this cable for programming a JP1 remote. After switching the interface to a DuPont 3x2, it worked perfectly.