Now Fully Greased and Ready to GO! 15 Diameter THIS IS NOT A 15" RIM Laminated Tire Tail Wheel Assembly 1-1/4" Yoke Shaft With Needle Bearings

The price is right compared to first party. Shipping time was perfectly reason within expectation. And it's doing what it is supposed to. It looks and feels strong enough to at least be equivalent to the OEM, but we'll see. Might end up being better.For now, very happy with it.

The tail wheel on my bush hog bit the dust after 25 years. This seems to work fine, but the center hub is 3/4 inch as opposed to the 1 inch it replaced. Time will tell if it holds up as long as the original it replaced.

Tail wheel for R60 BUSH HOG. Those wheels take a huge. Eating . The original u left as long as I could and so it is in an not repairable condition, I thought no problem I'll get a new one. The tractor store up the road wanted 450 dollars for oem replacement. I'm in 95.00 as ND have an up graded laminate wheel to boot. I had to return first order due to incorrect measurement on my part. Everything is taken care of no problems great quality I will be back for sureNote... They even explained how to measure the product prior toe purchasing it .... Totally my fault. There was a 20 dollar restock fee fyi so listen to them the first time.

Fit perfectly on my 6' drag bush hog.

The product is a beefy replacement for the stock assembly for my Rhino SE8A mower deck. The shaft that joins the wheel assembly to the mower deck however is just a tad too large. I had to hammer it on and after about 4 hours of continuous turning in the field it finally turned and maneuvered freely . It may have been correct diameter before it was painted/powdercoated so I would grind down the yolk shaft before install and grease it well. Other than that it works great and is way cheaper than a stock replacement.

Fit perfectly on my old 6' Howse bush hog. Very happy with the purchase. Great price.

I bought this to replace the tail wheel on an old 5' Woods M5-4 brush cutter. I measured the tube where the wheel shaft goes at 6" and thought this 6" shaft wheel would fit. Unfortunately, I didn't look at the 5.5" free play spec for the wheel, so the shaft was not long enough to protrude through the tube. I ended up cutting 3/4" off the tube on the mower so that the shaft would go through it and let me put the pin on the other end. But the wheel assembly itself is very heavy duty and will probably last longer than the original.

Quality product for the price point. Holding up well so far.