TEKTON 1/16 Inch Roll Pin Punch | 66061 | Made in USA

I've had several Tekton punches before, bought locally, and really they're pretty decent. Still marked made in the USA...I suspect maybe by Wilde or Enderes, which have both always put out good tooling. Tiny long punches like this 1/16" are comparatively delicate (all of them, even the highest quality ones) so keep that in mind and if your pins are particularly tight fitting, frozen, or rusted, then use a drop of penetrant and a center punch to get them started, then follow through with this one. That usually still works just fine with roll pins as it does with solid pins and is the smart approach to preventing punch heartache or scratched parts. If you're bending them you may be using them incorrectly and you have to keep in mind that with the smallest punches like this, they are supposed to bend rather than shatter (there is a good metallurgical reason for this and nobody sells small punches with a heat treatment that makes them extra hard/stiff...you don't have enough mass to accommodate it until you move up to larger sizes). The tip on these actually measures the same as the current Starrett, which is a hair over 1.5mm (.0597...1.516mm) rather than 1/16". If that matters to you you'll have to look elsewhere but it'll be hard hunt. Behind the tip, these are correctly and very slightly relieved for clearance (.0590) but less so than other brands...enough to help, though. Usable pin length is just shy of an inch (about 24mm). If you need more length and can do without the nib, the Gedore 1.5mm punch gives you about a quarter inch more to work with (30mm) and is an excellent punch (Starrett still being a bit better steel but also not offering any long pin punches below 1/8"). No reason not to recommend these punches from Tekton and the handful of others I've had have served very well...just use them smartly. It's nice that they will stand behind defective (or abused) punches the way they do...almost nobody else will do that...and still manage to keep the pricing low.

Easy to bend, but they’re tiny. So that’s to be expected.

Works great for BMW f30 brake caliper pins. This punch fits perfectly in them.

It broke, free and easy tekton warranty replacement, poor usps lost it, contacted tekton and they sent another. Tekton gets 5stars, 1/16” roll pin gets 1/16th of a star

this is a decent 1/16th punch. I've used it for a lot of things, I need another one, these smaller punches don't have enough metal in them so they're a little soft. I've bent this one numerous times. if I take a little time and use a brass hammer I can straighten it back out and continue using it till I bend it again. Eventually the end will break off and I'll order another one. They work well enough and it holds up to the abuse I give it. This is my second one.

And it works!

I use for disassembly of some firearms. It is comparable to Snap On, Mac, and other big brands in quality and durability. The price is right on point. Save yourself some money and buy these if you need a good punch. I have other sizes from TEKTON that are just as well made.

It is a bit expensive but hopefully it will be the last one I buy. It is quality steel.

Punto muy fino

Tolle Qualität, habe mir aufgrund meiner Erfahrung von dem meist benötigtem Treiber gleich einen als Ersatz zu einem Komplettset bestellt, aber nicht benötigt... endlich eine Qualität die das Austreiben von sehr stramm sitzenden Pins vertragen...

nice equipment

Great product!

Really high quality. Works flawlessly removing pins from my polymer firearm.