Spring Loaded 510 Connector (Low Profile) 22mm by Unknown

This 510 connector is excellent. Although I dont recommend it for wiring an illuminated switch. The positive pin hole on the side makes it difficult to fit the spring and retainer back on once you have the two wires soldered in place. You dont want to sloder the wires in wile it is assembled because you can melt the plastic. Other then that it is an outstanding connector and will order again for future builds.

These work well for most DIY Vape mods, just remember to remove the pin before soldering, a paper clip or the wire to be soldered pushed though the hole on the pin keeps the spring and bottom brass housing in place while you do it. Otherwise you will most likely melt the black plastic coupling piece like I did a couple of times.

Is what it is. Works great and I have had zero problems with it so far. I like this one as compared to another I bought because it is easier to solder. I wouldn't use it for any high powered builds but as I built this into a mount that goes on my Ohm meter to check resistance in coils before trying to fire, works just how I need it!

Other than the ground ring these decks will get the job done. I just wasnt crazy about a crimp design for the ground, so I hammered it flat and soldered the wire to it.

Very nice product, however when you try to solder to the center pin, and stay just slightly to long it will melt the isolator and the center pin will come flying out. Other wise a little epoxy later, it is working flawlessly.

was smaller then I thaught but that's my faught all else was great keep up good work

Worked for while but then the center pin broke off.

I bought this in hopes it would work well and I could get it here fast with prime. It did get here fast, but I put it in my newly build box mod (correctly built, I should add) and put my Mutation X on it. It fired my RDA for all of a half second before the plastic spearator between the positive pin and the ground melted and shorted my batteries out..

looks good enough but check your plastic isolator as soon as you get it. Mine is cracked.... Might be useless

Great 510 connector for Box Mods.