⚙️ Power Your Passion with Precision!
The Brushless Motor Controller is a high-performance PWM driver board designed for DC brushless motors without hall sensors. Operating within a voltage range of 5-36V and capable of delivering up to 350W, this controller features over-current protection, a heat sink for efficient cooling, and is suitable for a variety of applications, ensuring both safety and convenience.
V**O
This is not plug and play, but it does work well
You must absolutely know what you're doing with this thing. There's zero documentation, and connecting to a motor requires some serious knowledge and experimentation to get right. It will only work when you're using a 3 phase BLDC motor that includes hall-effect sensors. Those must be wired exactly correct along with the motor power phases or else you get nothing.That said, it does work. I've been able to connect two of these up to two separate motors and can control them with an arduino via PWM on the potentiometer pins.Not for the faint of heart - but this product does what it says.
M**I
It never works
I connected to a bldc motor, did not use sensor, powered to 30v. The light is no. The board draws very little current. Turned pot. Nothing happened.
S**R
zs-x11b motor controller is what i got it needs a hall sensor to work will not work without one.
I used this motor controller with a small 12V 10Amp brushless motor with hall sensors it works great. doesn't work if you unplug the hall sensor connector. I did not get the forward revers switch with mine and it has a small board mount potentiometer. The motor controller in the picture doesn't have the hall plug with is the z-x11a.
C**T
Defective!
Doesn't work. Tried low volt motor, no output, tried higher volt motor, no output and now in a permanent dead short condition.
Trustpilot
1 week ago
2 weeks ago