Auxbeam H11/H8/H9 LED Bulbs, Upgraded F16 Plus Series LED Light Bulbs 70W 18000lm Led Bulb Kits 500% Brightness Halogen Replacement Bulbs with 3RD Generation IC-Driver Plug & Play

The road is lit up😁

Nice light

Lights are nice and bright and gave me no issues with the vehicle electrical system. However kiss your radio good bye the electrical interference makes it almost impossible to listen to FM radio. I really do like the lights but I am thinking about taking them back out just so I can listen to my radio.

I have installed these in the low-beam positions in my '16 Honda Civic EX-T with low-beam projector lamps.The installation was very quick and easy and did not require indexing of the LED stalk to maintain factory cutoff. The cutoff line of the LED is at the same height as the factory Halogen bulb. The scatter above the cutoff line on a vertical surface is noticeably broader and brighter, perhaps about 30% greater (without any equipment to measure - just comparative observation).Driving with only the passenger LED as a test, the LED cutoff on the road was cleaner than the Halogen and almost gave the impression the Halogen was lighting better since the up-road scatter was greater with the Halogen. However, the Halogen was significantly dimmer and did not illuminate as precisely as the LED.Driving with both LEDs has been exceptional. On both rural roads and town streets, I have not once been flashed (which happens periodically with the significantly older LEDs of another brand in my 4Runner). The cutoff line is clean and not distracting, and natural scatter illuminates beyond the cutoff about as far as the halogens did, but with cleaner white light. The Civic uses 4-light Hi-beam illumination (both the low beams and the high beams). I kept the Halogens in the high beam since it uses a reflector instead of a projector ( I may change to LEDs in the future). The high beams still improve long-distance and wide-angle visibility meaningfully beyond the low beams which tells me the LED scatter is not competing with High Beams in terms of oncoming-driver intensity to any significant extent.The fan noise is noticeable but not annoying when the engine is off, and is totally imperceptible when the engine is running. The LED driver fits neatly in the hollow of both front fenders near the headlight. There is enough wiring to make fitment easy but not so much that you have an annoying amount of wires to deal with.I'll write more in the future if there are any problems such as flickering, brightness degradation or color drifting. But for now I'm very pleased with the purchase and am considering purchasing a pair for my Suburban.

Heard great things about them and tried them out. Loved them until just now. Only lasted 2 years. My HIDs have lasted twice as long.

Had my first bulb go out just under a year. They did warranty it and set me another set. That set lasted 8 months and had another failure. I was told the warranty is only from the date of purchase and doesn't reset when the new set was sent out. So basically you have 2 years of led lighting before you'll have to buy more, or change companies. Other than their inability to be reliable, I did like the output and color. No issues other than lifespan length and warranty details.

I initially though these were a good deal and they performed well at the start. Very bright and easy to install. Over the last year, I have purchased 5 pairs that are installed in 2 cars. After a few months, one pair developed fan noise and sounded horrible, like it needed lubrication. After some back and forth with the company, they sent out a new pair. Replaced them both and sent back the originals.Then another few months later, my other car had one of the low beams just stop working. I figured I was almost at a year, and it wouldn't likely be covered by warranty, so I just bought another set. It was probably the LED driver. The other one in the same set had a reduced light output as I noticed it when I installed the first new one and compared side to side. I decided to replace the other so they would match.Now, only 4 months after installing the new set, fan noise AGAIN! I am fed up. I took the noisey one apart and found something interesting. THEY ARE NOT BALL BEARING FANS!! The ad claims, "Built-in ball-bearing fan with 12000R/Min, ensures maximum heat dissipation and prolongs lifespan of LED bulbs over 50000 hours." Well, the attached picture shows what the fan shaft is actually spinning inside of... A cheap bronze (maybe) bushing. No wonder these things make a little noise - even when they are new. I feel totally scammed and will never purchase another Auxbeam product again! Deceptive advertizing....crappy build quality....Done! BUYER BEWARE!!

2023 Tacoma Trd off road. 1-1 replacement. Plug and play. 5 min install. No flickering, nor error codesThese lights keep the same beam pattern as factory just a much more crisp and centralized bright white light.I replaced hi and lows. High beams light up the world. Literally feels like driving in full day light and I live in the mountains where 0 visibility at night.I RECOMMEND THESE LIGHTS!!!

Compré un Juego en el 2020, poco después se me dañó una de ellas, solicité el reemplazo, por las políticas de Amazon no pudieron enviarme un reemplazo, y me hicieron la devolución de la compra (Aprox. el 90% de lo que pagué, pero me quedé con una buena). Volví a comprar otro juego y hasta el día de hoy Oct. 2023 han funcionado bastante bien y aún tengo una extra por si se daña alguna de ellas.

I like the brightness and output however I've only had these a few months and now the fans are making a loud noise on start up. They were quite a pain to install because I was sent 2 driver side collars so the passenger side light pattern is too high.

I bought this product to replace my worn, old and dim halogen bulbs in the Low beam on the FRS. FRS uses a projector housing for low beam while high beam/DRL uses a reflective housing. The installation of the LED and the Can-bus driver went pretty smooth, just make sure you buy some 3M tape to stick the driver to the fender liner (clean fender lines with a dry tissue, get rid of dirt, use AutoGlym Vinyl and Rubber cleaner, wipe it off and stick it). The only hard part for me was getting my old halogens to get disconnected from the headlight harness.The beam pattern was like stock and did have a cut off while having a longer throw, looks night and day; I wish I had done this sooner.Just make sure that the positive on the can-bus matches the red side of the headlight harness otherwise it will not turn on. No flickering issues or shutoffs or dark spots were observed. when installing make sure the LED chips are set as Left/Right rather than Up/Down.Definitely recommend this for cars with projector housings.

Easy enough install! Excellent visibility! The only flaw is I lost my day time running lights. It seems as if when lights are on auto, my truck is confused and trouble messages get sent to the dash.

Bought An Auxbeam H11 LED Headlight Bulb and it was defective.When I tap on the black box that is part of the wiring harness, the bulb turns on, then turns off.The bulb works because it turns on after I tap that little black box, but whatever is in the black box seems to be defective.