DIYAH High Gloss 6D Black Carbon Fiber Vinyl Wrap Sticker with Air Release Bubble Free Anti-Wrinkle (12" X 60" / 1FT X 5FT)

Great product and easy to use completely happy with the results

The media could not be loaded.  I've used Vvivid matte and gloss CF vinyl. The gloss version was pretty good, but this one looks almost indistinguishable from real carbon fiber. I included a comparison photo between this one (left) and the Vvivid one (right); you can see clearly the Vvivid film is just a printed pattern, while this 6D one has a deeper, 3D affect to it as it goes around curves like a true CF trim piece would. Installation was not bad. With patterned films like this, especially with a complex layering, you can expect it to be a little bit thicker, but this one was easy to work with and responds well to heat. Just make sure not to use too much heat/stretching to avoid distortion.I also love that this comes with printed grids on the back of the backing paper, so it's super easy to cut what you need. I haven't seen this on a vinyl roll before.I had to take off a star for the packaging unfortunately. This should've been packaged on a cardboard roll. When you get to the inside of the roll, the film wrinkles as you can see in the picture. Unfortunately those wrinkles will remain after installation. I tried pre-heating and post heating, but you can still see them at certain angles. The film also does come up a bit short of a foot in width, so beware of that if exact measurements are important to you. Didn't measure the length. With better packaging, this product would be perfect.I know there are concerns about water getting inbetween the laminate, so I will update if I run into that issue here. I made sure to tuck all edges downward or horizontally to avoid this but we will see. In my experience with other films, the water does dry out and doesn't return after the first few rainfalls/washes, but time will tell. Will also update if I run into adhesion problems.

This is the third time to use carbon fiber wrap, the other two were ok. This film has gloss finish and seemed to be a lither thicker than the others I’ve used.I wrapped a new splitter on my Corvette to match the true carbon fiber side skirts. This wrap is as easy as the others and the price was better.Well pleased.

Very good quality but need to add directions on how to install

As soon as I started peeling off the vinyl it tore, I have be wrapping got quite sometime never seen this happen. Also it didn’t stick on some spots. Car was clay bar to remove debts and prepped well.

Looks great especially when you wax or use wrap detailer but very hard to work with does not have air release like other vinyl (3m ,Avery etc) once laid very hard to lift up and reposition, if your trying to use this on a car and are working alone I recommend to not waste your time you will need multiple people especially for a hood or roof where you only have limited strength to lift upwards

I used this to reburbish an old drum set and I'm VERY pleased with the results.It came in a perfect roll with no creases, was easy to cut and install with the warm-soapy water method and laid out perfectly with no bubbles and the adhesive has just the right stickiness.The drums now look awesome!! Good stuff!!

The media could not be loaded.  This was my first time wrapping anything by panel over all it was good it was thicker then you would want if you try to pull a little too hard it will rip or if you over stretch it was good stuff tho the clot is nice stretches really good with heat it’s really good overall I would recommend just have to take your time and know some what of what your doing don’t pull aggressive or it will rip I bought extra so I can test it myself and then use after trial and error