Type B & Rotatable F6T5/WW LED Tube Light - 9-Inch 3W (6W Equivalent), Warm White 3000K, Double-End Powered, Frosted Cover- 110/120VAC (Not a Plug-and-Play)

These work great in an old magnifier lamp. I have had to replace these twice due to voltage spikes on my incoming power. Once when a truck hit a nearby power pole and the wires arced together and once during a high wind event which caused the wires to hit together. No fault of the F6T5/D LED Tube Light If you tend to leave these powered on most of the time, connect your lamp to a good surge suppressor. Great tubes!

Love the color of these lights. Just what I was looking for to better balance the lighting in this room. I bought three for an inspection light fixture.

I put this in a camping lantern to replace a florescent bulb. Since it is rated at 3 Watts versus 6 Watts for the florescent, expect longer use between battery charges. This bulb is a little less bright than the one it replaced, but does the job.

Nice product, used these to replace burnt out lights in my wife’s make up mirror. The crappy Chinese ballast in her name brand mirror burnt out. So rather than make more waste I removed the ballast and old lights then installed these bulbs. It’s now obnoxiously bright, but I should have bought a lower brightness, that’s on me. Convenient that these can be wired with direct line voltage. Would definitely use these in other applications.

I took out the ballasts and rewired the fixture its better than new!

we needed to replace the 3 fluorescent bulbs in a very old magnifier lamp. we opted for daylight since my husband uses the light to look at slides. the conversion instructions made us confident in removing the starter. really happy with the result.

Installed in my vintage bar clock, wasn’t difficult to follow directions and bypass the original ballast although I wish the product came with extra wire and twist caps so the conversion can be done all at once. I also wish the light was double sided but doesn’t really affect the use for me. The bulb is much brighter than my original fluorescent and the color is quite nice. I will definitaly be converting any other florecent light fixtures to LED from now on. It took me less than a half hour to complete

Requires bypassing the ballast if replacing neon.