Moonlinks Bed Rail Stake Pocket Covers Compatible with 2014-2018 GMC Sierra 1500 and Chevrolet Silverado Stake Pocket Hole Plug Covers 1500/2500/2500HD/3500HD(Set of 2)

Perfect fit. I unwrapped it and installed it. Easy peasy.

Should have bought these a long time ago instead of struggling with all the leaves and debris getting in the stake holes/hand holds. They are a perfect fit for my 2019 GMC Canyon and give it a clean, smooth look. Snug going in, but a few taps with a rubber mallet did the trick. They definitely will not pop out. Great price compared to other sources. Very pleased.

They fit tight in the truck bed holes. They do have a slight raise off the bed of the truck. I do mind the raised part . It covers the hole of the truck and it works. Fits 2021 silverado.

It fits snugly & color is perfect match to my existing stock bed liner. The only problem I had was installing back left side was a bit difficult, as it kept wanting to slide out/ pop back up before I got it all the way down snug. These only fit one way so no alternate way to snap in. I had to work it quite a bit & hammer it w rubber mallot to get it to finally snap in. Facing tailgate, this was left side. The right side has no issues fitting snugly into place. I kept looking for defect or snag preventing left side from going all the way down but couldn't. Only thing I could think of is either my Bedliner left side hole is slightly off on pointed end by a centimeter or two, or the plug itself was slightly defect around curved corner where it wouldn't quite fit good. But they're both snugly in place now & fit nicely & prevent water or snow from getting inside the bed of my truck. I'm still happy with this product and recommend it for those having missing tailgate Bedliner plugs.

Tight fit, but works as expected.

Item was well made, sturdy. Visually it was perfect and matched the bedrail’s design. HOWEVER, it could not be coaxed into the bed rail of my 2015 Chevy Colorado. It started in about halfway easily. After that, there wasn’t much movement even using rubber mallet persuasion. Yes, I tried the fit on both sides, no difference. It was a chore getting them out after beating them in….resorted to a claw hammer to carefully pry them out.

Covers fit well but slowly raise out of pockets over time.

Perfect fit 👌🏾