WINFREE Rear Sight Rail Scope Mount Standard Scope Base 1913 Picatinny for Low Profile Red Dot Optics

Added this to my WASR-10. Pretty solid rail that eliminates the need for the side-mounted options you usually have to consider. More than enough rail for a Reflex sight, etc. Strangely enough, looking down the center channel of the rail lines up with the "iron" sight out front (mine's reflective plastic but anyways). Even with the optic on haha. Almost useful. For anyone struggling to remove your original back sight with the spring, the easy method to remove it is pretty simple. Lay a shop towel or rag over the sight piece, line up a sturdy flat head screwdriver into the center channel of the sight right over the joint, and just whack the bottom of the screwdriver. The sight will just pop out (the rag keeps it from flying, similar to popping a spring in a tremolo equipped guitar or other such). Take a pair of plyers and just pull the flat spring out out, you don't need it and it will make putting this rail in almost impossible. Of course, with the varying builds of AK's your mileage may vary. On my WASR, I didn't need to grind or modify anything, it all lined up nicely and worked correctly. Worth buying for sure.

Very surprised on the quality, which is pretty good! Easy installation too.

Good, solid mount. The only problem is the main screw it comes with is too short. Had to go buy one with a bit more length. Over all well worth the money if you dont like side rails or optics on your handgaurd picatany.

Will not fit a Chinese type 56 SKS. The part that goes on the spring tensioner is about 25% too thin. Meaning even if fully tightened it can rotate 5 degrees. Also will require a dremel to get the mounting holes to line up. It also blocks the ability to load with a stripper clip.

Doesn't fit. Easy to remove a d replace the real sight but this Chinese trash can't be installed

I have this installed in my AK-47. Installation was easy and product works great. I would recommend this base to anybody.

Just installed on my lancer tactical lt728 airsoft ak47. Perfect. left the spring in. just push down on spring while holding unit in place, insert the screw, the 3 "leveling" screws work great- get it level, tighten the screws down a bit, rock solid. Since its airsoft, i don't expect it to move since there is virtually no recoil pressures. if it does I'll locktight the screws later. (read some earlier reviews with instructions on how to easily remove old sight, you'll be glad you did) very simple.

Worked perfect and at a fourth of the cost of other options that I looked at.