Ergotech Triple LCD Monitor Desk Mount Stand with Telescopic Wings, Fully Adjustable Mount for 3 Screens up to 27 inches, 25 lbs. Weight Capacity per Pivot, Black, (100-D16-B03-TW)

Have conducted a ton of research on triple-monitor stands before purchasing this item.After receiving, I can tell you that this is probably the best stand in the price/performance category. This was much less expensive, especially when Amazon has it on sale, then the competition, but the build quality is definitely top notch.If you are going with 3 x 24" or 27" monitors, then the Telescoping Wing option is very near mandatory, and I'm glad I did. This way I can adjust the side monitors easily at a 45⁰ angle (and they could go much more) and then slide them both slightly behind the center monitor to remove the dual bezel look. With only one bezel on each side, it adds greatly to the surround immersion & isn't noticeable after a couple of minutes!One major benefit that I didn't really think of at the time of purchase, but very glad this stand offered.....is the metal base that is perfectly flat and is less than 3/16". When moving items around my desk, you can easily slide other items over with no impact (i.e. keyboard, etc...). Even though flat, it easily provides more than enough weighting for the 3 monitors. Moving in & out of my desk, this stand has never wobbled, even the slight bit. Very stable. It is 18" wide by 16" deep, and by getting rid of the other 2 monitor stands, opens up a ton of desk space. Found out I could be a lot more organized. Also, I can use the stand as additional horizontal space (i.e. cell phone, glasses, sticy tabs, etc...), which I couldn't do if it was domed, like some of the competition. One item I added, but not worth taking a star off for, is that with the stand finish on my laminated desk (could be the desk) is that the stand tended to slide during the adjustments phase, so I added a handful of small clear rubberized stick-em pads to the bottom. Not noticeable, barely adds to the height and really helps keeping the stand in place.The stand was well packaged and protected. Setup is simple (others reviewers have complained, can't understand why) and didn't even need the 1-page instructions. It's a vertical pole that slides into the base (and tighten), then you slide the horizontal bar with wings down over the vertical pole (and tighten), install the VESA bracket to the center monitor, tip up at a 45⁰ angle and lower onto the horizontal bar (tipping forward, it will lock in place with a locking pin), loosen the horizontal bar and adjust the height (easier with 1 monitor than 3, then retighten), extend the wings (two screw handles on the back allow this), then do the same installation process for the other 2 monitors, and lastly adjust the vertical screw handle on each side monitor to level the height (a small level does help). Done! Also it is preferable to have 3 identical monitors with a loaded ICC profile for a consistent image that spans across all 3 monitors.My 2013 PC Build:* Corsair Obsidian 800B full tower* Asus P9X79 Deluxe motherboard* Intel Core i7-3930K CPU (oc'd to 4.4 Ghz)* Corsair Hydro H100i CPU water cooler with 2 x 120mm reservoir (Corsair Link v2)* Corsair 4 x SP120 high performance fans (push-pull on the reservoir)* Other fans: Corsair 2 x SF140, SP120 and included case fans* G.Skill Ripjaws Z Series 4 x 4GB, DDR3-1600, low latency* G.Skill 2 x Dual Memory Fans (blue LED)* EVGA GTX680 OC'd video card* 3 x Asus VG248QE 144Hz 24" Monitors (res=5760 x 1080)* Rosewill Lightning 1000W PS* OS drive: Samsung 840 Pro SSD 256GB* Other drives: 2 x Samsung 840 SSD 500GB, 2 x WD 1TB HDDs, Segate 1TB HDD* Win 7 Home Premium

For me, the stand holds three 24" asus vg248qe monitors. I have set them up with side monitors angled, for my liking, at ~45 degrees for use on flight sims, fps shooters, and code work. This stand, having telescopic wings, allows for up to 3 x 27" monitors (but the viewing angle for the monitors wouldn't be as adjustable with the wider monitor size). I am not sure why the description on amazon says triple 26"?? The stand base is quite long (18" x 16.5"), but is flat and I am able to place a center speaker on it, to make use of the space. The stand frees up more desk space compared with the 3x stands I would have had to use, without the Ergotech. The entire stand can be put together, by one person and with monitors mounted, in about 15-20 minutes. It is very easy to set up and the two required allen tools are included. If your stand isn't level, you might have to have an additional allen tool for finer adjustment, however, I didn't have this issue. The vesa 100x100mm (also has 75x75mm) bracket size and included screws worked well for my installation. The brackets and pinions are very functional and I had height, width and positioning set for all three monitors, in ten additional minutes (due to being picky). I found them rather easy to adjust, however, some of the allen bolts were a bit snug and had to be loosened. The brackets can handle monitors up to 26 pounds; my monitors were only 13 lbs per monitor. The quality of this stand is excellent. It is not an artistic piece (nothing fancy), however, it isn't an eyesore and blends in well behind the monitors. This stand is exactly what I needed for my home office and I would recommend it to anyone. My monitors are safe and secure and I have gained much of my desk back, due to Ergotech's engineering. The warranty is solid, and you can actually buy additional parts and turn this stand into a six monitor setup! Other considerations: I would recommend getting some sticky rubber feet to put underneath the monitor base, in order to keep it from sliding around on a slick surface. It's heavy and won't move on it's own, but you can easily slide it around on a smooth surface, with little effort. On another note, I called Ergotech to ask questions prior to purchasing this stand, and they were more than helpful/responsive. Overall, for the price and build quality, this stand tops the rest.

Now I wont beat around the bush. This thing is super expensive but when I have 3 27 inch 1440p 144hz monitors its worth the price. If you're willing to drop $1500+ on monitors why not go all out and get the best triple arm stand on Amazon.Super easy to assemble and the thing is solid as a rock. I have no fears about this thing tilting over.10/10 build quality10/10 looks7/10 price

I'm only using 3 X 24" monitors on this but I love the stand it's absolutely perfect in terms what I was looking for, adjustable in every aspect, extremely sturdy and has a great base mount! Installation is super easy and everything is detailed very clearly, Must have if you're going for your own triple monitor setup.

Ich bin durch ein YouTube Video auf diesen Ständer/Halter aufmerksam geworden.Kinderleichte Montage.Sehr Stabil.Da wackelt nichts.Ich hatte diesen Halter mit 3X Asus Ve 278q (27zoll) bestückt.Wahnsinn.Allerdings stand der Halter auf meinem Eck Schreibtisch und brauchte so mehr Platz nach hinten als ich gedacht habe.Selbst wenn man die Arme auf volle länge ausklappt und nur an den Enden jeweils einen Monitor befestigt,hängt da nichts durch.Wie gesagt.Super Stabil und trotzdem Einfach!Klare Kaufempfehlung !

But it cost alot of money

Using it for 3 x AOC G2460F (144hz) monitors and it's brilliant.Cable tidy helps keep the desk clear of wires.