12V Car Momentary Speaker Horn Push Button Toggle Switch 19mm | Auto Motor Red LED Light Metal Toggle Switches Waterproof

I use this on my 81 corvette with red interior. it would look really cool if I could wire power to it. Unfortunately my horn is a negative one and no power comes through the steering wheel- so the button works, but the LED light doesn't have any power. I drilled the proper sized holes through my three spoke steering wheel and just inserted them and wired them appropriately. But man I wish I had power to them. Thinking of using solar panels on the steering column if the aesthetics are pleasing.Also I barely have to tap them to blow the horn, but enough that I don't have to worry about blowing the horn accidentally. Too, there is feedback through the clicking sound made when pressing them so you know when you're closing the circuit.

Works exactly like they promised. No diagram with it which was surprising but found one on line because it is a standard switch. If yours ain’t working, odds are you have it wired wrong or burnt it up trying..........

It was good

The media could not be loaded. works perfect it's nice and bright. the only issue that I did not have but many people that are not come to electricity is the actual pins and what which ones are for 12 volt constant and which ones are load. it'd be nice if it came with a nice little pin diagram that's all. but all you have to use is a 9-volt battery and some paper clips and you can find out exactly which pins or what

Does not come with wires like shown in picture

Ok , for all you guys that wonder which pole is which ... The com is power in ... then you have "no" which means normally open . That means that when the botton is at rest its not engaged, or the circuit is off .. then you have " nc" , this means normally closed .. or that the circuit in engaged . Hooking to this pole means you have to push the botton to stop the connection... these are the three center poles ... then you have two poles on the sides . These are for the lite .. one is pos .. the other is neg .. some here say to connect the no , or nc pole to the pos. Pole .. i disagree.. here is why .. If you connect them like that then when you push the botton only then does the lite come on .. that dont make no sense. You can't see that its on because your finger is pushing the botton . Instead hook the pos lite botton to your headlite switch , the wire that comes from your courtesy lights . this way when you turn on your head lites the botton shines and you can dim it with your dash lites ... good luck , I hope this clears this matter up for you guys ..

Ordered this to go with my train horn I ordered at the same time. No wiring harness or diagram. Not too hard to figure out though. Could not the get the LED light to light up. Did not even hook it up due to that to see if the actual button worked I just tossed it in the trash. Would have cost me more than the cost of the item to ship back. Not worth the Hassel. May have been a one off defect. Just thought id let you know.

Quality product. As expected