ITBEBE Red RJ45 Strain Relief Boot Covers 100-Count Set for Cat5 Cat5e, and Cat6 Ethernet Connectors

I wish I had read the other review before buying. These boots are far too rigid. You cannot unplug a cord from a port without using your fingernail (or something else) to lift the snap-in connector. I used a handful of them for a small project, and as soon as I'm done writing this review, I will place the rest of them exactly where they belong; in the garbage!

I bought a combo of ITBEBE crimper, rj45 and boots to terminate my Cat6 cables and sad to inform that I returned all of it because the crimper was generating 1 out of 5 bad crimps. I don't know if it's a combination of all of them but the passthrough cuts when crimping were not flush, my cable tester kept saying there was a short and my devices were only getting 100FDX instead of 1000FDX speeds. I used my old crimper with ends that have a loading bar and they were perfect every time. The boots are too rigid and you have to slide them off the end to unplug your cables. Just thought I would save some money and sad to say, I just ended up spending 60$ more on the company that invented the passthrough crimper/connectors. Nothing like sweating in an attic trying to terminate cables because they didn't work the first time around.

I ordered a bag of these IT BEBE (100) strain relief boots for my 1000ft spool of Monoprice CAT6A (UL E467139 23AWG 4P CMR CAT6A UTP RoHS COMPLIANCE...) because the above description STATES that it'll fit CAT6A Ethernet cable. It does NOT. No matter how hard I try, it will not fit. I've even tried enlarging the boot's hole with a Phillips screwdriver, but that only rips the boot. The description on the bag does NOT cover "CAT6A". Buyer beware.

The boots were soft to the touch. So I created a small patch cable to test the boot. Once installed onto the rj45 connector, it became a bit different to press the connector clip. When trying to insert the new cable into a switch or patch panel, the cable wouldn’t click in. So I made another cable without the boot and it went into the switch or patch panel with ease and was secure. So I ended up returning the product.

Boot covers fit over the wire was good, not tight but enough to slide on the wire. The boot fit snugly on the connector. These are not soft rubber so you will need to press a little harder to unplug the connector. I don't find it that much harder to unplug. I don't think it is a problem.

Strain relief, tough to push on but the cable I used was direct bury outdoor cable with a thicker jacket

A tad tight on 6 and a tad loose on 5E, but works on all 3 as advertised.

good as expected

Only reason for the rating is that these boots have too small of a hole to feed a CAT6 or shielded CAT6 cable because of the larger diameter overall. Even trying to cut the back end doesn't work or make it aesthetic. If it was a softer rubber it might be able to. But for most who do CAT5 cabling because of the cheap cost it is good.

Good RJ45 covers, I'm using them to cover a bunch of broken RJ45 connectors of multiple cables.Good Quality.

I am really happy about my product but not so much with the delivery company. My product came in an Amazon bubble envelope which was open (product still inside) and thrown on my deck. NOT happy with Dynamex. I wish you would change delivery company!

Conçu pour la finition de câble réseau RJ45, avec du câble Cat5e ou cat6e, sa fonctionne.

They look good but they're pretty stiff.. they get rock hard if a little cold.