Soap Dispenser for Kitchen Sink, Built in Sink Soap Dispenser (Brushed Nickel), Countertop Soap Dispenser Pump with 47" Extension Tube kit, No Need to Fill Little Bottle Again (Longer Thread Shaft)

Good quality, easy to install and works well. No more having to deal with a small dispenser that over flows every time I fill it. Just put the tube into a full bottle of detergent and forget about it. I recommend this product.

I'm so happy to find a replacement for the pump at my sink for the one that went out. But not only is it a replacement dispenser, I don't have to refill the soap bottle anymore. I can run the tube to my large bottle of dish soap and have soap for months. I was worried when my dish soap came yesterday with a very largepour spout for the mouth of the bottle, thinking that when my dispenser came today It would not fit.However, this dispenser comes with several different size adapters to accommodate all bottle sizes So it fits perfect. This fencer comes in several different colors of metal to match your sink. And I'm happy that this one matches mine perfectly.It's sturdy metal not cheap plastic and looks as though it's going to hold up just fine.I will update my post if it starts to rust or faulter. The pump works great and puts out plenty of soap with each pump. I'm really happy with it.

Worked. Fits my Kraus sink. Was not hard to replace the old one I had that stopped working. And besides having to drill a hole in the dishsoap container I had. It works fine and have had no issues as of yet.

Very easy to install. No tools necessary. The hose is plenty long enough to reach the detergent bottle wherever you put it in the under sink cabinet. Comes with 3 different size bottle stoppers to get a good seal on any size bottle. Also has 3 clips to clip the hose out of the way under the sink. The only drawback is the width of the base of the pump. The specs say it is good up to 1.57". The hole I had was 1.375" and it was a little bit of work adjusting the position so it covered the hole evenly.

This device really sounded good, but operationally, it is greatly lacking and difficult to use.The problem is that the tapered cork that has to fit into the many different sizes of soap bottles, so they give you several to choose from, but at best, it is still problematic. When you are setting it up for the first time and each time you need to replace the bottle of soap, the bottle itself must be cleaned to insure that there is no soap on the inside neck of the bottle or the tapered cork will pop right back out. When you insert the tube into the bottle, if the tube from your prior soap bottle touches the inside neck of the bottle and gets any liquid soap on the bottle, you will have trouble keeping the cork in. Most likely the bottle has a residue of soap on the neck of the bottle from the bottle being tipped over in your shopping cart or grocery bag on the way home, and unless you clean it off so that it is not slippery with soap, the cork will not stay in, it will pop right back out.Save yourself frustrations and don't buy this lousy device as the concept sounds good but you will regret the effort that you will have to expend every time the bottle has to be changed.If you get the cork to stay inserted in the bottle of soap, you will then have to pump the dispenser some 60+ times to get the soap to refill the tubing, and you will wonder if it is even working because it take so many pumps with seemingly nothing happening. If you finally reach this stage, it will work well until the bottle is empty and you have to start the whole process all over again.What I finally dis was to take a long twisty tie wire (very long, or perhaps two or three tied together to make it long enough) like at times come on a bread bag and tightly secure it around the neck of the bottle in the threaded area so that it can't gravitate upward and take the remaining length and angle it up to the top of the cork and tightly wrap it around the cork and twist the ends together to secure it. This should hold the cork in place. After replacing the soap bottle many times I finally tried this method of holding the cork in the bottle. It probably would work to keep the cork in place even without cleaning the inside of the bottle neck from the soap that lubricates the internal edge of the bottle neck. I should have tried this the second time I switched soap bottles!

Just installed today and appears to work perfectly. Easy to install and seems like it will last.

🌟 Simple, Elegant, and a Must-Have Kitchen Upgrade!I absolutely love this soap dispenser—it's the perfect addition to our kitchen sink package.👍 Functionality & EfficiencyThe design is incredibly simple and easy to install, making it a quick and rewarding upgrade. The real benefit, however, is how it helps us optimize our soap usage. Instead of having access to the whole bottle, the dispenser provides a decent, pre-measured amount of dish soap with each pump, effectively reducing waste.✨ AestheticsAesthetically, it's beautiful! It has a sleek, clean look that perfectly matches our existing faucet and elevates the entire sink area.This dispenser is a winner for both its practical functionality and its stylish appearance. Highly recommend!

Easy installation. Works great! Took about 2 minutes to install. I like that you have a few different adaptors for whichever sized soap bottle you use. I wish I had gotten this years ago.

Me encantó el diseño y su practicidad

Le meilleur distributeur de savon que j'ai eu! Fonctionne a merveille, mais faut effectivement pomper longtemps la première fois. Mais après, c'est instantané.

This is the 2nd dispenser we put in. We took out the water filter and put in the soap dispenser. This time we put it into the laundry as we were happy with the 1st one which we put in the kitchen

خامه محترمه

No test of longevity yet but this works fine so far. The instructions are clear and thorough. Using this hose-into-bottle approach makes installation and refill much easier than fixed container types.