Koala 95% Clear Sticker Paper for Inkjet Printer, Waterproof

Waterproof and glossy my printer had a little trouble picking up the paper so it’s definitely better to print one page at a time but the results are so worth it!

Excellent quality. Will buy again. I use Epson 2840 Ecotank printer with this paper. Prints are awesome.

One of my favorite of Koala brand, great quality the value and u can use it for whatever u can print and the ink looks perfectly fine bright colors, the adhesion and the durability is perfect

The quality of this is amazing. I ran water over it and no drips. I sealed it with a clear gloss and covered it with epoxy. Still looks just as great as when it came out of the printer. Actually, it looks better with the epoxy on top of it. Just one of the sheets stuck in my printer so I just turned it around and it went right through the printer. Best I've used so far. To add, this vinyl is sticky and not very repositionable. If your project will allow, it is helpful to put coats of mod podge on the printed vinyl before applying. This "strongs" it up and makes it easier to handle. It does not curl up so much and get stuck on itself. It also keeps it from stretching if you need to pull on it a little if working with a large image. The more coats, the stronger. I probably did overkill as I applied 10 coats of mod podge but it made all the difference in handling it and positioning it on my project. It seriously cut down on the frustration. No worry of bleed at all.

After some initial setbacks— and sacrificing a sheet to continuous printer jams and a wave of irritation— I can say with certainty that this paper is WONDERFUL. Five sheets printed now, and every one is PERFECT. The ink is clear, the sticker is strong, and it wasn’t too difficult to remove the backing. I ran the sticker under water and actually tried to scrub it off for about 15seconds—no luck. That ink was not coming off. For reference: I used an HP-Envy 4500, and genuine HP ink cartridges. 61 XL I believe. A couple tips if you are having difficulties: FIRST- put a few strips of tape on the leading edge of the sheet to prevent the sticky side from catching in your printer when it tries to pull in the paper. SECOND- be sure to leave a few sheets of regular paper underneath, and use a small strip of tape to stick the top one to the paper tray so it can’t be sucked in with the sticker sheet THIRD- Be ready to give the paper a little boost when it first goes in, to make sure it feeds correctly. I used clear scotch tape on the leading edge to help with that, but I suspect a thin strip of regular masking tape would be more beneficial.

First time using this clear sticker paper and it worked great this will be my new sticker paper. Also I didn’t emerge my glass in water but I did wash it and the ink didn’t smear, and it was used with ink jet printer.

These were just what I needed for my project

Works in most printers. The only thing I really did not like about this product is that once you put it on something your image(s) disappear and it's foggy looking and doesn't look nice on the objects you put them on.