Cookology CHA600BK/A Energy A rated 60cm Black Angled Extractor Fan, Designer Chimney Cooker Hood (With Ducting Kit)

Not perfect. So here are the defects. The drilling template (as shown in the video) didn't arrive. The fitting instructions are woeful and the fittings are substandard (as they often are). There's no inventry of what should be included in the pack and there are odd numbers of odd screws and wallplugs. The instructions direct that you must use the fittings provided. I did and wish that I hadn't. Oh, and the carbon filters are the cheapest of the cheap.But anyone half handy can fit this without instructions and follow your instincts and experience and use your own fittings. I mean how much does a couple of decent screws and good wall plugs cost?But this extractor is otherwise great. Looks good and works well, with little noise compared to other extractors.

It looks smart, has a light, and easy to use. Reasonably priced too.

Not bad price and looks good

Delivery from courier a little disorganised as they attempted to deliver a day early. However I had made reservation to accept delivery on the date they had provided.Item was Well packaged. Cooker hood is light, instructions are not accurate due to how the English is written but its neither worse. Being in the gas plumbing trade it was easy for me to install. Probably for the novice installer it would take a few times reading the instructions but it’s doable...I was able to fit this single handed. I used a duct system/flue to extract direct to outside. It has 3 speeds and in my opinion it’s not loud. This was a simple cost effective good Hood for our small kitchen As it’s for temporary measure only.A decent item for its price.

This cooker hood looks good, the light is fine but the extractor fan is noisy and hardly works. The 3 speed settings do not work. You get what you pay for

Excellent cooker hood does what it says

For the great price this is a stylish extractor and looks absolutely great I would recommend this productFor an extractor fan I would say it runs without much noise and easy to reach controlsInstalling the extractor was quite easy I think a template would make the positioning easier rather than measuring where the holes are. The included metal ducting is where a bit more thought could have been done its a two piece sliding section which were to long even when closed up so had to be cut to size also the eletric cabel is in the ducting so has to come out the top I made an insulated cut out so the cabel is hidden but still it's a good buy. Both carbon filters are used one each end of fan housing.

Looks so expensive but for a good price and does the job well. Recommend, adds a modern look to the kitchen.