🔍 Elevate Your 3D Printing Game!
The 3D Printer Part UM2 m3 x 15mm PT100 Temperature Sensor is a high-performance thermocouple designed for Ultimaker 2 series 3D printers. With a 1.4m cable length and compatibility with various printers (with connector modification), this sensor ensures precise temperature control for enhanced printing quality.
A**Y
Perfect match for Ultimaker 2
Replacing the failed sensor in my Ultimaker 2 with this one was easier than I expected. It has the right connector and the perfect length. Another review expressed concern about the temperature range. Since the Ultimaker's highest setting is well below 300°C, I'm not concerned.
K**E
Junk, Not Worth The Headache
Worked for a couple prints before it started giving me temp sensor errors. Even when the printer is stone cold after sitting overnight, I can see the nozzle temperature swinging wildly. I made sure it was properly plugged into the board and seated inside the heater block.The ability to buy this part quickly and cheaply is nice, but it is not worth the headache if you have to replace it this often. I suppose the old adage, "buy nice or buy twice" is true. I will be replacing this with a genuine Ultimaker part.
N**P
Quits working
Had a hard time finding this part. Found this one and saw some negative reviews. Bought it to give it a try since cannot find one. Worked for a few prints then got the temp sensor error. So, if you can find one somewhere else do not buy this one. If you buy it be warned it may fail in short time. Buy at own risk...
M**.
Won't work above 350C
PT-100 RTDs are usually expected to work up to 500C and this seller claimed 450C, but the epoxy used to hold the wires together softens around 350C, causing intermittent shorts and losses of connection that stop the print.If I were them, I would at least use magnesium oxychloride cement instead of epoxy to hold the sensor together, or better, cotronics cement.
F**R
Passt und ist genauso wie es sein soll
Beim Upgrade vom UM2 auf Olsenblock ist mir wieder der Temperatursensor abgerissen... Dieser hier passt genau lässt sich gut verbauen, auch der Stecker Passt für den Ultimaker 2
M**L
Top Preis Leistung
Bis jetzt habe ich noch keine Probleme gehabt. Mein 3D drucker läuft den ganzentag und hat mit diesem Thermostat kein Problem.Auf jedenfall empfehlenswert.
D**B
Temperaturbereich bis max. 350°C
Wie vom Händler beschrieben, hält der Temperatursensor nicht 400°C stand.Die Leitungen verschmoren schon vorher. Für Materialien bis zu einer Temperatur von 260°C kann dieser Sensor gut eingesetzt werden. Darüber hinaus sollte man sich für einen anderen Sensor entscheiden.
Trustpilot
1 day ago
1 month ago