16AWG Wire DC 8mm Adapter to 45A Connector Cable, for Solar Panel Goal Zero Yeti, Compatible with Anderson Powerpole - 1ft/30cm

I'm making a DC-DC charger for my Maxoak 500WH Power Station and this fits the bill. I first tried one of the cheap DC 8mm cables and the plug was loose and made poor contact. This one fits exactly! MUCH better.Note 1- The cable is good quality and the wire actually seems to be 16ga copper.Note2- The DC 8mm plug has three contacts: Center pin, inner sleeve, and outer sleeve. The positive (red) is on the inner sleeve and the negative (black) is on the outer sleeve. This works for my Maxoak, and I'm happy.Note3- The Anderson connector arrived side-by-side, like the picture. (This can be easily changed)

I picked this up as a back-up / alternate connection for my goal zero battery system, and it's exactly what I was expecting. It has a solid construction and the length leaves little chance of entanglements.

This adapter was just what I needed to connect different solar panels to my Bluetti150. One suggestion to anyone looking at this adapter is to make sure your connections will match up before buying. The barrel plug is 8 mm. As others have mentioned, the Anderson power pole connectors may be put together in an orientation that doesn’t work for your needs. However, these can be undone and moved to a different orientation but could be difficult because there’s very little extra cord length to do so. A lack of quality control, which is a constant concern when buying anything made in China. Otherwise it does what it’s supposed to do.

Didn’t work for me with my Jackery 1000v2.

Would buy again. Good quality.

Works great

Good to have on hand for those odd jobs

Tried to connect a GoalZero solar panel to a Jackery Explorer 500. I rearranged the ports at the solar panel end from the Anderson arrangement to GoalZero's, which was not hard. But the 8mm connector would not connect with the Jackery. Checked with a voltmeter that it did carry voltage, but I think maybe the center needle is a bit short? I bought this because one of the photos of the product shows it's compatible with Jackery. I didn't want to send back due to the fact that I needed this, so I cut off the 8mm port end and spliced a spare one I had that is compatible with the Jackery 500, and all was fine after that. Took me a while to figure out what the problem was and fix it. Not sure about the possibly misleading advertising for this product. Or perhaps there are different Jackery 8mm ports?