Profeeshaw Stainless Steel Prep Table NSF Commercial Work Table with Backsplash and Undershelf for Kitchen Restaurant 30x24 Inch

The table is shipped with a complete protective plastic cover over the top and the shelving unit. The table itself, when constructed, is fairly heavy, so you will want help in being able to erect it once the legs are all bolted into place.The leveling feet are really sturdy and well done, however, I did not need to utilize them as a table itself was really flat on all angles (I checked it with a level)The manual states the table can hold up to 870 pounds. I’m going to be using it to support a 110 pound freeze dryer along with the accompanying vacuum pump. My load on it should be less than 175 to 200 pounds total when I’m using it.The lower shelf does not have the same load strength as the top, however it will hold a good amount of goods. Really nice table for the money!

Love this prep table! Quality, easy to put together myself.

Assembly was easy, taking maybe 10 minutes. You’re given the option of installing a fixed base or casters. The fixed leg bases are height adjustable and pressed into place, so don’t install them if you ever plan on removing them. The casters are nice and heavy duty but the installation method is a little unusual, tightening a washer down onto a rubber bushing, causing it to bulge and become a friction fit inside the tube legs. It works, but a little different than I’m used to. Fit and finish is nice and the table was received with no damage. It does seem a little on the high side, with the top of the table above my belt line, but I’m also short, so YMMV. Set screws are used to tighten the bottom shelf against the legs, so be careful putting too much weight on it - I think the shelf is sturdy enough, but how tight the set screws are will dictate how much weight it holds before sliding down the legs. Overall, it feels like a heavy, durable, stable and well built table and I have zero qualms about putting expensive equipment on top of it and will be ordering several more for our business.As others have noted, the film is difficult to remove, but if you peel small sections at a time and avoid tearing it, it shouldn’t take more than 5 minutes to remove.

The quality of this table exceeded my expectations and it is quite rigid (30 x 30). The packaging was good and it arrived undamaged. Assembly is simple and intuitive. I wish it was offered with casters, like the 24" tables.

Easy to assemble well made and sturdy. There was a dent in the back but I needed it right away so I didn't return you can't see it when I put the oven in front of it that I had intended to place there

I really like this table for my craft room, but I’ll tell you this about the item. 1) take the plastic wrap off before putting it together, this was the hardest and most frustrating part for me. 2) You really don’t need 2 people to put this together, I’m a girl and I did it by myself. 3) when assembling put a towel down to protect the table, 4) don’t take those little screws all the way out.. you’ll be sorry!! They are hard to put back in, and finally you need a measuring tape or ruler bc you need to measure the legs to make sure they are all even, I measured from the groove. It’s really nice .. oh and get stainless steel cleaner.

The packing wasn't secure enough, but I contacted Amazon and solved the problem.The instruction made me confused because of the incorrect English and the fact that the illustration and the actual product don't match.Push out with the broom handle or some other long bar from the other end and take the plastic cap off.And push sown the caster's black rubber to shorten it about a quarter to half an inch to fit the legs.The casters are strong and smooth.

Love these tables have ordered two they work out great only wish they came with leg pedistal that bolt to floor that way your sure to get the right size