Front Load Washer Tub Bearings & Seal Kit for LG & Kenmore etc Replace 4036ER2004A 4280FR4048L 4280FR4048E 4036ER4001B Rotate Quiet Deep Groove Ball Bearings

Ordered these because we thought the bearing was going out on our washer, turns out it wasn’t. But we replaced them anyway. It was nice to have the quickly, and easy to install. Months later and they’re still running great. We have 6 people in our house so we do a lot of laundry.

Fast delivery, fit like it should,.habe been running for 3 months without problems

A+

These bearings are sealed. Oem bearings are not. The bearings fail because the shaft seal fails allowing water to enter the oem bearings. I expect the seal included with the bearings will fail because the shaft is now pitted. It will leak but the bearings should hold up.

It fits well and works well. Only problem is it was working for only two weeks until started making noise again. I checked and the bearing is gone.

Arrived with some rusty looking marks on the edge of one of the bearings. Hopefully that’s not an issue down the road. Much cheaper than the factory parts. Replaced the bearings in my lg washer.

This bearing is a lot of work to replace it worked for about 50 loads and started making noise and needs to be replaced again save your money by OEM

Just what I needed and fit perfectly

Both new bearings fit well perform well in the initial wash. The parts are not of top quality but they are of decent quality given the low price. The water seal looks OK. The tub gasket is too big for my LG model WM1333WH My original LG parts LASTED 16 years. The drum-side bearing (large one) failed because the seal failed first. Water got in and the bearing rusted and failed. The small bearing was just fine but it had to be removed so that the large (bad) one could be removed in my situation. Basically, the bearing quality is not critical. A bearing lasts as long as the water seal last plus one year. Because it SO HARD to remove the bearings from the drum, I would inspect and replace the seal every other year. If you drain the residual water at the water pump clear-out and the water has rusted color, your water seal is shot.

I saved a lot of money by replacing the bearing on my washer instead of buying a new one. I think this kit was under $50. Took about 3 hours to disassemble. Replace the bearing and put it back together. These bearings are totally sealed as the originals were not. They should last longer than the originals

Failed after a year and a half, don't buy it.

Quality seems to be hit or miss. The first bearings we received were gritty and no good. The second set though seem great. Don't listen to anyone who tells you this is an easy job to replace these. There is no way people are doing this in 2-3 hours as some claim in these comments. You need to be very handy and have lots of tools. Be prepared to spend at least a full day on this, probably more if you plan on cleaning everything before reassembling (which you should.)

I bought first pair and installed without popping the seal and checking the grease. Within a few weeks after installing the LG washer was getting louder and louder and is clear the bearings are going. I ordered another pair and this time I popped the seals, the bearing barely had any grease in them and the grease that was in there appeared to be pretty poor quality. I filled them on both sides with a heavy duty grease prior to installing.