Bando USA 4PK805 OEM Quality Serpentine Belt

This Belt was purchased for my 2007 Highlander Limited power steering. As you can see from the pictures below, it looks different than the belt made specifically by Bando for Toyota under part number 90080–9 1088–83. Comparing the front and the back of the two belts, they appear to be made of different materials.The reason I’m replacing the belt is it squeals when I start the car.I will install it and report back in a month or two.

This belt was correct for the air conditioner compressor position for my 2007 Subaru Outback wagon with 2.5L SOHC engine.The size, width and groove pattern matched those on the belt it replaced, it went on easily, and it has been doing its job for several months and several thousand miles. Though I can't tell whether one brand belt is any better than another, I have used Bando brand belts before without any trouble. They are made in the US, and Amazon pricing is hard to beat. You just have to do the research to make sure that the part number is right for your application.

Easy install on a 2002 Sentra GXE.-loosen belt tensioning rod (long bolt with 12mm nut) as well as the bolt that tightens the tensioning rod in place (no need to loosen too much just a few turns)-loosen the tensioning bolt as much as possible **** back it out 1.5-2inches and you will not need to get under the car or reach deep in the engine bay to loosen up other bolts on the power steering pumpOnce the rod is sufficiently loosened you can rock the power steering pump forward while you slip the belt over the water pump pulley, which is the pilot closest to the top of the engine.Slip off belt and use a long screw driver to push the new belt first over the crank, then over the power steering pump pulley and finally slip it over the water pump pulley, may need to force it slightly.To check correct tension after tightening reach down between crank and power steering and twist belt, it should just be able to barely flex to 90 degrees.Done

This belt is a perfect fit in my 2007 Yaris, and appeared to be exactly the same as the OEM belt, even to the printing on the belt. I am giving it 4 stars instead of 5 because it is squealing a lot, especially when the air conditioning compressor starts up. I have checked the belt tension and it seems to be okay. I am not a professional mechanic, however, so I can't be certain if the squealing is because of a flaw in the belt materials, or because i installed it too loose or too tight. The squealing lasts a couple of seconds then stops, until the next time the vehicle is started cold. If the squealing is in fact my fault for installing it with the wrong tension, then that's not the manufacturer's fault and the product deserves 5 stars.Be careful before ordering and check the belt that's in your car for the exact size. In the Bando part number, the "4PK" refers to the width, "4 Ribs wide", and the 1180 is the length in millimeters. There's no guaranty that all Yaris's of all model years used this belt.

I needed to replace the power steering belt in my 02 Nissan Sentra since my car was squealing and becoming hard to turn. I knew the belt hadn't been replaced in a long time so I figured that was the cause. Luckily I did, because the old belt was in bad shape!This belt was the perfect fit and sized very closely to the original. While incredibly difficult to access and install in my particular car, the belt itself fit great and my steering is smooth and quiet again!Since my car uses a separate serpentine belt for the alternator, I picked up and replaced that one as well.  Bando 6PK1105 OEM Quality Serpentine Belt

I bought this belt as amazon said the fitment was correct. Well I checked back later to write this review and it changed to say the fitment is incorrect for my truck... Weird but it definitely does fit just fine. It's an absolute pain to install but that's probably due to the fact that it's in a really tight spot and has to fit around the large crank pulley. It is a definite fit, it's the same length and rib count as the original belt.

The right length and does the job for my 2007 yaris sedan with ac. Groove patterns dont exactly match the engine pullies like the oem belt does but the engine doesn't seem to care. Works great for now. Engine now starts better without squeeling. Hope this will last.3 month update: after the belt had broken in for 2 weeks, it squeeled again from a slight stretch because the groove pattern had perfectly dug into the pulley grooves and matched together. So I adjusted the tension and it's been very reliable and nonsqueeling. No more signs of tension loosening

I don't like writing bad reviews, but its important to let everybody know if something is really bad and this is. Its cheap rubber, thinner than original and so will not work. If it does then it will for just a little while, but I can't say for sure because mine never worked because it kept slipping off. To make matters worse, I would have to pay to return it. Frankly, I'm going to be avoiding buying here because of the return policy. Why should I have to pay to return an item that is not what I wanted?

I used this belt to replace a 1999 Honda CRV power steering belt. The old belt was squealing during car startup. After a few minutes the original bell would stop squealing. The install was simple and the rib count and length were the correct specification as per the Bando website. After installation the belt no longer makes a noise when the car starts up. The new belt was far more pliable than the old brittle outgoing belt.

I installed these in July and they broke 2 months later in early September. The the ac/alt belt split and it took out the p/s belt which broke in half or visa versa I don't know which. I would like to request a refund but I see no way of getting in contact with the seller. I would not buy again. I paid a bit more and went with ac delco.

Used for my 2004 odyssey. Changed both the ps and serpentine belt with bando. Both belts are high quality and no squeals. Make sure your serp tensioner is not leaking and might as well replace it if it’s the original with 200k miles on it.

The Nissan brand belts on my G35 were replaced at the dealer before I got the car 8 years ago were starting to crack. These belts were a good price, the correct size, and appear to be similar to OEM quality. They installed easy and make no noise.

I cannot tell you how crap it was!I broke only after two days of installation and really let me down. It made me stay in the cold till being tawed. The company and the client service of Amazon took no responsibility to pay the consequences of their deficient product.Terrible!!!I would definitely not buy it.

Parfaite pour Kia Rio. 100% identique à l'original. Top achat !

Excellente qualité. Comparable aux courroies d’origine Toyota.

Not for my type of vehicle even after I selected the year make and model of my truck

Served its purpose and met our needs

Bonne qualité

Perfect fit and good quality, the belt was the same bando brand I replaced from the car after so many years.

just like what I wanted.

👍

Great

As described