WOWTK Smooth Dash Console with Pop Up Gas Cap fits for Harley Touring Electra Glide FLHT Road Glide FLTRX Street Glide FLHX 2008-2024,Chrome

It’s just plastic but if you are looking for a dash to put on top of the stretched tank covers from advanblack this WILL work!! You will need to modify it slightly to make it sit right. If using on stretched tank covers you will HAVE to get a 10/24 x 5/8 long button cap screw for the front as the stock screw will be too short. The rear mounting bracket will need to be bent up slightly on the bent down towards the frame then the mounting flange bent down. I also cut it from the back edge up into the mounting hole to give it a little more adjustability then put 2 washers between the bracket and the frame so you’re not flexing it so much that it breaks the dash. The best way to do it is just put the cap on the tank then keep bending the bracket slightly till you get the cap to line up with the hole the best. Also only use one flat gasket and the round seal gasket to get the cap to sit flush. DO NOT crank down the front screw just throw a little lock tight on it and get it down far enough that the front settles onto the tank. Also on the rear bracket to avoid the “poking through” issue just add one lock washer to each one. It will space it enough that it won’t poke through the plastic on the front and also helps secure the screws to the bracket better so they won’t come out. Over all I think it looks great you just need to spend a little time moving things around to make it a perfect fit. As far as using it on a stock tank I would assume it will slip right on as the rear bracket is identical to the factory Harley bracket. Just remember to still use a 10/24 x 5/8 on the front.

It's says it fits my bike and absolutely does not. The gas cap is horrible and does not screw in. I would skip this product 100%.

Purchased knowing it was a problematic part. My stock console fits crooked and I’m blaming HD for it. This one needed the metal bracket cut away to have a U shaped notch at the bolt so that it moves forward enough to match the opening with the fuel cap. Took a dremel with a burr to the hole up front for the hex capped screw into the tank, adding a stainless washer for good measure. Used the stock console’s rubber side strips. Wound up using only one rubber washer to make the cap sit flush when it’s screwed down in place. My seat fits better with the smaller console profile. Also added washers on the two screws on the bracket underside- so they didn’t bottom out . Was nice to see brass nutserts used on this. I was prepared to set my own if need be. Still a better deal versus $230+ on a plastic painted console that’s never in stock.

Great product

It was a good value for the money. It is better looking than the stock one that comes on the bike however the fit of the cap is a little off.Really easy to install with just a few bolts to remove and a little clean up. I have had it on my bike for over a year and the color is holding up well.

I installed this on my 2016 Harley Ultra limited and it looks great and was very easy to install.

From the second I took it out of the box I knew I had made a mistake. But I installed it anyway and seen the fuel cap does not fit flush....then I noticed the mounting screw in the front of the tank caused the plastic to crack and the chrome film to flake away.WORD OF ADVICE...If you spend 50k on your bike and another 40k in upgrades....dont go trying to do something on the cheap. It never ends well.I contacted the company about a refund and said they authorized it as soon as I send this back. I did two weeks ago and STILL havent gotten any kind of refund from them.UPDATE...This company RIPPED ME OFF.They promised a refund and its been over a month since I ordered this piece of GARBAGE and returned it and STILL NO REFUND.WHERES MY MONEY???

This is by far the worst aftermarket accessory I have bought for my 2011 Harley Davidson number one the same as I already scratched when I got it not bad but you can still see it if you’re up close does not align correctly with the contour or the bike I spent almost an hour and a half put in this piece on if it wasn’t such a pain in the butt I’d take it off and ship it back do not buy anything from this company you’re gonna be better off spending the extra cash and getting something from Harley Davidson. Also the little pop up desk cap is a piece of crap too I have to keep the little pop-up mechanism sticking up so it doesn’t get stuck. Total waste of my money