24407 TEMPILAQ Advanced Temperature Indicating Liquid, 163 Degree C/325 Degree F, 2 oz. Ideal for Heat Treating, Brass Annealing, and Glass Production, Made in USA

I use it to set the time required for properly annealing case necks. Paint it inside the neck and let it dry. Once in the annealer it will go to liquid as soon as temp is reached. Once the settings are correct I make the run. Only a little is needed for the set up. The bottle will last a long time for this purpose. Make sure to shake it well to mix it before applying.

The media could not be loaded. I have been annealing my brass at a buddy's house for a few months and we use Tempilaq (specifically TL060) to gauge when the brass is properly annealed. It's very simple: swab a little on the inside of the neck and run it through your annealer. (My video is done with the AGS Annealer.)It doesn't get any simpler than that. This stuff is a must for consistent annealing!

I use the 700 and 750 degree TEMPILAQ to adjust the flame and rotational speed of my Annealeez brass cartridge annealing machine to achieve the ideal temperature range. Serious reloaders know that cartridge brass work-hardens with each reloading/firing cycle. Hard brass splits and lacks consistency. Annealing returns the brass to factory new ductile condition, and can be done many times. The "magic" is knowing exactly the right temperature and time so brass isn't over annealed, burned, or "just warmed' without any true softening. This paint works GREAT - but it always dries up in the bottle before it is used up (regardless of tightening the lid and storing in another air-tight container). I may try the pens next - although more expensive per oz of paint, they may actually last longer.

works great

I like that it changes colors when at temperature. Using it to reach the correct temperature when setting up my Ugly Annealer for rifle brass.Sacrificed a couple pieces of old range brass as an experiment. Hint I put a line on the neck and three more places going back to make sure I wasn’t heating my brass to far back on the case!

It was useful for what I needed it for. I tightened the top well but still was mostly dry when I needed it again. So, give the top an extra hard twist.

It evaporates in the bottle. I used it two or three times applying literally small DOTs of Tempilaq on brass for annealing for a total of approximately 15 dots. The bottle is now half full, not because i've used that much but because it quickly reduces itself when you open the bottle. Buy the thinner and refresh your bottle here and there... also keep the mouth of the bottle very clean. Otherwise you'll have to break through a cap of dried tempilaq that has gathered on the cap and the bottle mouth.That said, yes, it is useful for annealing as a temperature indicator.

Began annealing brass and this was what I needed to make sure I’m getting the temperature I need. This bottles gonna last a very long time. Worth it