APT Advanced Polymer Tape(2'' x 36 Yds (108FT)) 1 mil Thick Polyimide Adhesive high Temperature and Heat for Masking Soldering Electrical 3D Printer Application.(2 Inch)

I paid a lot of money for this item thinking it would be good , i was using it to put on my 3d printer bed but it is very hard to unroll infact that hard to unroll the tape deforms so it wont go on the printer bed straight so give this a wide birth . Ive no use for this tape now so i just use it for packaging and wrapping boxes i think the problem is its very very old tape or has been left in the sun or in a very cold room hence the problem

OK for non-demanding applications, but this tape is not as mechanically strong, and the adhesive is not as uniform, as in the original DuPont/RS Hughes Kapton brand. I use it for taping protective plastic sheets to the floor, for non-demanding HVAC work (ducts and adapters). since it leaves no residue, is stronger than aluminum tape, and does not have a smell.

Used this to protect a latex mould as i wanted to go over the latex a with a 3D pen.This worked really well and protected the latex from the heat of the pen.overall i am very satisfied.

I use this to protect the back of a motherboard in a printer, on a heated bed, under the clips (CR6 SE) without any issue. I also use it so some higher temperature applications. The adhesive seems good and it does seem to have the correct heat resistant.

Used tape for powder coating, pre baked the compressor housing at 450 for 25min to burn off any oil residue and the tape did not lift or curl, peeled off with no issues or residue left behind, put a new piece on for powder coating and had no issues peeling it after baking for 20min at 400. So far it works perfect for powder coating.