INJORA Tow Hook Drop Hitch Receiver with Ball Buckle for 1/10 RC Crawler

Works very well for my custom trailer projects, I have used these sets for years and always had consistent results.

This is a fantastic scale hitch. I used mine on my trx-4 high trail with a Racers Edge 1/10 Scale Full Metal Trailer and it looks amazing and is fully functional. I would just say, IN MY CASE, I had to drill out the hole just a little to get it to fit on my trailer. Like i said, that might not happen to everyone. But it was easy to do and fits like it was meant to be there. I would 100% recommend this product to ANYONE.

Works fine .

Hitch is good and solid. Just a little confusing on where all the nuts and bolts go but over all works as it should, I’m keeping it for a spare.

Looks good.

Looks great. Hard to put together. No instructions as to what screws go where. The tongue does not lock onto the ball well and pops off easily. The lock on the ball also does not lock down. The size of the threads do not match up to the diameter of the trailer threads. Had to fabricate several pieces. The locking device on either piece however is the biggest failure.

As discribed

This does the job just the pintle hitch latch at the top is no use. Why even put that in the bag unless it was actually a pintle hitch. It just sits on top of the ball and does nothing, plus I never see any hitches like that with a latch on top, only a pintle hitch.

Looks Great. Installed on a FCX10 blazer with an Injora bumper. Would give 5 stars, but had to drill and install a pin to get the pintle hitch to lock. Use Loctite on small screws, I had one back out.

Very happy with the trailer kit. Even came with cool stickers

But no instruction for all bolt and nuts

vraiment cool