BrightSource Dodge/Ram Headlight Dust Caps, fits 2013-21 models (projector headlights)

these worked perfectly when installing my HIDs in my ram1500 - I needed about 1/4 inch of extra clearance for the bulbs and did not want to leave the headlight without a dustcap as that can lead to problems later on, these worked perfectly and gave me the extra space needed - bonus that it comes with all the cutouts and grommets as well, I was not expecting that.

Purchased these to install my wife's new LED bulbs from Lasfit and prevent dirt, water and bugs getting into the housing and ruining things. These work perfectly, all though they could be about 1/8" deeper and I already contacted the manufacture but they didn't seem to care these still work well. I only had to remove the rubber grommet to allow air flow as the fan sits right against the cover but otherwise works perfectly and has for the last 1500 miles with no issues.

Installed on Ram 2500 with halogen projectors. Fit and finish are great I used these dust covers with Lasfit led lights with the cooling fans. The cut out on these were spot on and have rubber dust covers that seal nicely. The 2 reasons for 4 stars is the price is high and these covers do not include the gasket so you will need to reuse the ones from your original dust covers.

The dust cover fit in place of the original as advertised. Mounting holes lined up with no problems. There are two minor issues with the product. 1). It would be nice. If the dust covers came with new rubber gaskets. 2). The covers are not deep enough to accommodate an LED light with a fan. The fan housing buts up to the backside of the dust cover forcing the user to either leave the grommet off or to cut some away to allow proper air flow. I ended up cutting slits in the grommet to allow more air flow. The depth of the cover needs to be another half inch at least to accommodate fan housings.

Easy to install, didn't give loads of room but did give a bit wiggle room if you've upgraded to brighter led. Works as intended

This product fit 99.9% perfect. One screw hole was slightly off but still seated perfect in my eyes. Gives extra room for the LED bulbs. Plus rubber grommets if you need to feed any wires through for my custom friends out there.

Needed these for the install of some high end LED bulbs. Still too tight on the high side, furthest away from the low side. Bulb rides right up again the cover. Had to squeeze the cover on.

Fit great if you have HID

Loved how well the product worked. Fit perfectly

Perfect fit, easy install, made it possible to adjust my LEDS now

Used to change out the lights in my 2015 dodge ram 1500 to LEDs ome cover didnt give the room needed for the fan header on LED.

Fits good. Does the job as I would expect.

works just like factory