BG4276 2.1-Amp 6-Inch Single Speed Bench Grinder with Flexible Work Light, Black,orange

Well built, Easy to install, Easy to use, Works well. Good Quaility.

Works as it should. Has a little vibration but not bad. Good value for the price.

It works great. Has a strong motor.

Good and cheap. In spite of complaints assembly was fairly easy. There are instructions and they could be better but they were adequate. (see pics) There was talk that the light only comes on when the grinder is switched on. Ours came wired so that the worklight is independent of the grinder. We leave in on as a nightlight. If you are at all handy with electrical you can wire it however you like. The socket is a typical E26 houshold lamp size and is limited to 40W. If you prefer incandescent 40W isn't much but a 5W LED provides plenty of light, a 10W LED would be overkill. No bulb is included. Mounting was harder than it should have been because the 2 mounting holes are in the middle of the mounting plate on each side under the motor shaft (see pics). This positioning makes installing bolts from the top nearly impossible. Holes in the 4 corners would be better. My solution was to use stainless steel toilet tank bolts inserted from below, held up with the plastic retaining clips shown in the pictures. Tightening was done from underneath. If you plan to do it the same way make sure you have bolts that with a head that can be turned (slotted, hex, phillips, etc.) not a carriage bolt or a typical toilet to floor bolt. The grinder works good with minimal vibration. Starting torque is low so it takes a few seconds to spin up, seems normal to me. Considering this was the cheapest 6 inch grinder available it is great in spite of any flaws.

Excellent value for the money. The motor runs smoothly and delivers plenty of power for the tasks it’s designed to handle.

Good quality.....quiet....just needed something to sharpen tools occasionally......for $50 bucks ...great bargain....🍻

This is my third Wen tool, and like the others, great value. I needed it for sharpening bits, so at first, I didn't like that the tool rest was not adjustable, but discovered the best way to get the correct angle is by eye.

Perfection for sharpening my beginner lathe tools

Es lo que necesitaba, dude mucho para decidirme ya que pensé que no tenia la suficiente fuerza para desempeñar su trabajo y me equivoqué, suficiente fuerza para renovar filos de cualquier herramienta en casa

Buen producto precio calidad, no hace mucho ruido y el foco que trae es ser mucha ayuda.

Es práctico pequeño y ayuda mucho el foco que trae yo solo lo utilizo para afilar cinceles o hacer pequeños detalles pero para eso esta muy bien

No he encontrado defectos en el producto, se ve de muy buena calidad, tiene fuerza y la vibracion es razonable, todas las esmeriladoras vibran. La relacion calidad-precio es insuperable