Creality Capricorn XS Series Low Friction PTFE Bowden Tubing for 1.75mm Filament with PTFE Teflon Tube Cutter Extruder Hotend Creality Assembled Extruder Hotend

I wish the tube was 2 inch longer

Seriously, avoid like the plague! This has caused me more grief than anything, as regards 3D Printing. It should be not available to buy, simple! The cheap rubbish 'other brands' are far better, and at least I get a few prints out of them, this stuff is not worthy. You will soon be wondering why your extruder is ratcheting and making all sorts of noises with this stuff. It even melted into my hotend so bad, that grips wouldn't remove it. Took me a while to realize that this stuff is just pure garbage, and if I could send it back, I would. Please, as it's hard enough to decipher what goes wrong in this fantastic hobby, but do not get this tubing under any circumstances, or you will have a world of pain. You have been warned :)

Easy fit and tighter tolerance than a standard ptfe tube, this one came with a cutter to ensure a nice square end.Just be sure to measure your requirements for length, not so long its flapping all over but not so short it's being pulled or kinked when your hotend is at the limits.Works well and keeps that filament flowing smoothly.There may be other options but this works well for me, just be careful not to run it at very high temperature or it will off gas. All ptfe does it so its not a fault of the product, just do your research before buying to ensure its right for your purpose.

There has been no issues with this, I bought it for my Voxelab Aquila which is an Ender 3 clone, it works fine does everything it is supposed to do, never blocked up and the temperature according to the control panel is always spot on, very little variation maybe 1 degree up or down but it always corrects instantly. Go get this if you need it, it has done very well for me so far.

Did'nt work well straight from the box. The bowden tube wasn't inserted well and stopped extruding.After heating up and fitting back together it worked fine.

This is the same as the hotend on the Ender 3 pro bought in 2020, came with 3 socks and some spare nozzles, the bowden tube was the perfect length and it is indeed Capricorn, the dark blue XS type so all in all a good buy.