Anabond 666 Rtv Silicone Sealant, Clear,100g

Curing time of 10-12 hours is bit high but it works fine after that.

Works fantastic between metal and silicone case. I used it for reapplying my magsafe ring to my silicone case. Please follow the instructions for good results.

I had a Crack in the rubber gasket of my fridge door. The fridge company said the gasket is not available even though the fridge is just a few years old. I researched a lot of products and finally bought this one to give it a try. I cleaned the gasket / rubber with a dry cloth and applied this and kept it overnight when fridge would not be in use (approx 10 hrs). I Checked in the morning ang and most of the Crack was sealed and since it's silicone the adhesion was nice and flexible. I used it again 2 night later to cover up any remaining parts/cracks left out in the previous application. And it was DONE. The Crack / gap was sealed. Be careful while apply because it leaves a sticky paste on the fingers. Here are my thoughts: Pro: - Quantity is good for the price Rs 190 - It's in a tube so easy to use unlike other silicone that require a separate gun to be purchased plus easy to store away and keep - adhesion / seal is quite good and joint is flexible - It's opaque / semi transparent so doesn't look too bad especially is applied correctly. Con: - It's in a metal / aluminium tube so application is a it difficult as in we have to squeeze harder but too hard a squeeze and to much comes out. - found it difficult to use with nozzle as we have to squeeze a lot for a little to come out. I used my finger to apply - tube hole dries up so need to use a nail or pointed object to open up the hole for next use. Overall I'm happy with the product and will easily recommend it.

It's not one of those adhesives which bonds instantly as soon as we apply it but by God it's one of the best adhesives to stick any surface to any surface but of course you need a bit of patience. Just clean the surfaces free from dust,water,etc that you want to stick together then apply Anabond 66 as much as you feel is required and press the two surfaces against each other. Wait for the adhesive to dry completely and lo and behold you get one of the strongest adhesions in the world. An absolute value for money thing. But mind you it has a tendency to solidify at the mouth of the tube which gets blocked but using a pin we can remove the block. The body is old school i.e made of aluminum so need to be careful while pressing with excessive force when there is a block at the mouth of the tube,that's all.

If you are buying this to make moulds, please DONT ! It doesn’t work well for a mould.

Fantastic