Double-Sided Acrylic Adhesive Strip for Vinyl, 50-Feet

I used this to install sheet vinyl flooring. It worked great! So far, it has held well, and I haven't had any issues; however, the project hasn't been done too long. I will update if there are any problems down the road. This was one of the only places I could find this tape, so I appreciate its availability. It was easy to use and made laying the flooring pretty easy, overall.

si es un buen producto funciono

Exactly as advertised. Works good.

Sticks like you would expect. I wouldn’t really call the tape! There is a gummy clear film with thread like lines on it looks like clear glue. If you try to cut a small piece the gummy glue will just roll off the tape into a ball on your scissors. If you apply it directly to the floor carefully with the brown paper backing it will stick to almost anything. The after you remove the brown paper backing you are left with a gummy strip. Then press your vinyl flooring directly on top of clear gummy stuff it will stick.

I'm doing a van/RV conversion and I used this to stick our plywood subfloor to the rigid foam insulation that sits underneath it. I tested the adhesion of a small section of the subfloor and the insulation started coming un-glued from the floor (used Loctite PL300 to attach the insulation to the van floor) before the plywood did. To cut it, I just used a utility knife to cut the strip after I had laid it down, no issues. Scissors probably would have given my problems given how sticky the glue is. I may end up putting screws through the floor at some point either way, but the floor isn't going anywhere with this tape holding it down.