SwanstoneBS01515.010 Solid Surface 1-Hole Dual Mount Single-Bowl Kitchen Sink, 15-in L X 15-in H X 5-in H, White

The outer dimensions are correct. Inner, not so much. The dimensions are 11 inches approximately 9 inches for bowl. Other then that, quality looks and appears fine. Flat bone finish.

I bought this to install on a lanai bar to replace an old stainless sink. We live next to a brackish water canal and even the stainless sinks become tarnished and nasty looking after awhile, so we thought we'd try this composite sink. It's very nice looking and installed easily. I did have to drill out the two holes to mount a double valve faucet. The instructions say to knock them out, but I was too chicken to pound away on the composite when I have wood drill bits that accomplished the same thing with a 100% guarantee of success. You just turn the sink over and you can plainly see the center of each faucet hole knockout, indicating where to drill. Actually, I did try a few raps with a hammer on those knockouts, but they appeared to be a bit too thick and were not going to simply break away on their own. I recommend drilling. The sink comes with the four mounting brackets - one for each corner. I bought some plumbers putty for setting the sink that is specially formulated for use on plastic as opposed to metal. I don't silicone glue anything as it always seems to leak and makes it difficult to remove the sink. My installation turned out nice.

Wasn't what I thought I ordered. It was replacement for something I had in my cart that was porcelain not fiberglass. This was for my kitchen makeover. It took a long time to get also.

The only thing I'd do differently is wear gloves and a long sleeve while handling it. Because ita fiberglass it sheds it an makes you extremely itchy!

This sink is NOT white. It is bisque or ecru. Also, it is so dull and scratched looking. If this was going to be a slop sink, sure. But I needed a small white sink for my van conversion and this is definitely not it.