Wire Crinkle Tool for Jewelry Making, Manual Wire Crimping Tool, Rounded & Pointed Texture, Best for 22–26 Gauge Soft Craft Wire, Beginner Friendly

You may have to play with it a little bit at first but it's well worth your play because when you couple it with the rest of your design you will be quite pleased how your piece wll end up looking.

Maybe it is just me, but I find it hard to push the wire through without it sliding under the wheels. Wheels took some fiddling to get them on the pegs securely. This tool is a great idea but wish it was a little easier to use. Handles on bother wheels would help. Not sure what to do about the wires slipping under the gears though.

Crap hard to work, then wire doesn't stay in place. Yet you have to hold plastic with both hands. Absolutely crap

For use when you want to produce into your jewellery making something a little different. Makes two different shaped crinkles with ease.

The crinkler works nicely, but 2 things I would change about it: 1. The knob to turn the wheel is rather small and doesn't provide much leverage. I found myself grabbing the entire gear to turn it. 2. the guide hole is fairly useless. There should be an additional lip on top of one of the gears to hold the wire down so it doesn't ride up and over the gear. As is you need to hold it/ cover it with a finger to keep the wire between the gears. All that said, it does a nice job. I'm glad I made the purchase.

Nice crinkling tool, nice shapes.

This tool is lightweight plastic. The wire slips under the parts and messes up your project. It will not crimp a wire larger than 22 Guage. Basically useless.

This is very hard to work. I saw spots where the plastic was already cracking. I couldn’t get the wire to stay between the discs it kept wanting to go under the discs. I had to return it.

Great product and efficient postal service

It’s ok, it is functional but a heavy wire will not flow through it to make the crinkles .. likely the best gauge wire is about a 24! I was able to struggle to get a 22 gauge wire through it The way it is assembled doesn’t leave enough room for a heavier gauge wire

Es para doblar alambres de cobre muy delgados como calibre 24, 26 o 28, 30, más gruesos ya no.

Personally I struggled with this product! No instructions meant it was a case of trial and error! Eventually I worked out that the wire must pass through the tiny hole or it pops upwards and does not crinkle! When it works it looks good but for every success I had 10 failures! Got me so frustrated I eventually gave up and used a thin pencil to curl the wire round which worked much better and lowered the stress levels! Plus I do think it was pretty pricey for what it was! Shall end up at the back of my office drawer I think!

First, it is small and hard to turn, hold the tool, and ensure the wire does not go over or under the wheels. The corners are very sharp and can hurt your fingers while holding it. If your wire gets under or over the tool, it is impossible to replace your wire. The wire wastage is awful, yes you can salvage as much as possible but you end up with a ton of scrap wire to get the desired length of wire crinkled. Don't waste your money!