RV Awning Lights, 12V 16.4FT Blue Camping Awning Lights, Motorhome Travel Trailer Food Trucks Van Waterproof Canopy Led Strip Lighting, RV Exterior Underglow Light

Installed in the same channel on our RV as the lights we replaced after 9 years...slid in perfectly. Used about 1 foot of the attached adhesive on each end to secure the light strip in the channel and sealed over both ends with clear silicone to further secure. Used existing camper wiring...installed using twist connectors and filled connectors with silicone to waterproof. So far, working great...and the blue color adds a nice touch to the campsite!

Easy installation, quite nice color

Easy install and works as good as the higher priced ones

I have the blue strand of lights. They are bright and provide a nice ambience. Mine have been in use for one month. All LEDs work but at the ends of the strip, where not protected from UV by the awning, the clear rubber overcoating is already beginning to turn yellow. So far, the yellowing has not affected the color of the light. In the literal sense, installation was easy.... clean off the trailer surface, peel the adhesive, stick on. However, remember, the LEDs require power and you do have to plan that all out. That's where 90% the install time and effort are spent. Some don't seem to realize that. I tapped into a 12V source in my trailer's wiring, mounted a new switch on the wall, installed a covered, waterproof junction on the outside of the trailer, and connected the lights there. Because others have complained that the 3M adhesive strip didn't stick well, I also added mechanical retainers every 2' of LED strip length. So far so good but it's been only one month. I'll be watching the yellowing of the clear rubber overcoating to see how or if it ever worsens sufficiently to affect light output.

My fifth wheel did not come with a light strip from the factory. Was able to tie these to an existing switch and man they work nice. They do not change colors but I’m not taking my trailer to any raves so it works for me.

Very bright and the adhesive sticks very well. Would recommend!!

Didn’t try to install until after the warranty expired. Brought them camping again this October and tried again. A few lights come on, but not the entire stand. Not even 10% of the strand come on. Poor quality!

These lights were everything and more than I could’ve asked for point we just purchased a brand new Coleman camper and needed some outdoor lighting underneath our awning. The install was easy and the adhesive on the back was plenty strong enough to hold nice and tight and has been holding well for the last six months. Look forward to testing them out in nature.!

The Tape that comes with these lights to install it is absolutely useless. There is no stick to it whatsoever. The little clamps to install works great. I had to buy 3 M tape. They are easy to connect for power and do look great. How long they'll last is hard to say.

Used for RV under awning in front of entrance

Lights are super bright. Easy replacement for our burnt out ones in the awning. However we installed them on a clean surface and within 24 hrs they had all completely fallen off.If they stuck better I would have given more stars.

Got these for my travel trailer when I opened package spool of lites was tiny I was very skeptical . But the strand fit my 16’ awning even had to trim a bit . Brightness was way brighter than I thought for tbe size ! In fact with white sides of camper and awning it glows just right .

Lasted on the camper for 3 weeks. Adhesive tape let go after. Went back to the $10 strips that use 3m tape. Our last cheap set is still going after 4 years