Mr.Shield [3-Pack] Designed For Sony Xperia 5 III [Tempered Glass] [Japan Glass with 9H Hardness] Screen Protector with Lifetime Replacement

I have been using the same company for screen protectors, on my phone and husband's, for the past 6+ years. Always happy to come back buying the same brand over and over again. The company stands by life time warranty if protectors cracked.Personally installation of the protector is always easy if handle with great patience, care and common sense. Clean well, wipe the screen dry completely, and start with the top aligning with the camera first. Peel the the top part and stick it to the phone, and slowly peel the film slowly while keeping the alignment straight when continuously working your way down. I find working in direct sunlight is the best because it's easy to spot any dust that gets their way on the screen during installation. Make sure using one hand to hold the screen protector while using the other sticking all the dust down before securing the protector on the screen. If you are not a meticulous person, have someone to help with removing the dust on the side for you.The screen protector leaves a little bit of edge unprotected but this is nothing new. Like I said, I've been using curved corners Xperia phones for years, and there are NO protector that covers the the entire screen as far as I know. And none of my phones, or husband's, ever, got any scratches or damages on those unprotected areas. We use phone cases with a front cover as an extra protective measure. If circumstances I need to remove the phone case (like when I work out I need to stick the phone into my leggings,) I just be careful not to drop or abuse my phone until I get up and put my phone back into my case.This is a great phone case. On our older phones using the same company, we did have cracked cases few times but usually they lasted for more than a year or two before we had to replace any. I'm talking about 5 phones that we have used in the past so we're experienced shopper with this company. When we ran out of replacements, we just contacted the company and we got shipped a new replacement immediately. Save your cracked ones because you might be asked to ship it back as a proof.Another note. Try to install it in one setting. If you keep lifting and putting it back, your case definitely cracks and breaks after few times.

I’d say that the protector have been working well for probably two years although I do not drop my devices that often and I don’t go outside of my house that often as well so probably that may have a bit of a bias for the length of how long the glass is working, but I think The quality of the glasses is good, but I like the mechanism of how I installed the glass I think you guys did a good job on that so I want to also make a positive comment on that aspect as well.

Very happy with the quality of the screen cover and how easily and smoothly it adheres to the screen of the phone. There was almost no issue with bubbling, which is perhaps why they have significantly downgraded the quality of the included bubble remover; a flaccid bit of plastic which is far too flimsy to be very helpful in that endeavor. The included dust cloth was also very small and gauzy, but functional. The stickers were fine.I purchased the screen cover for a Sony Xperia 5 iii, and the one significant disappointment was that the cover did not go all the way to the edge of the screen, either horizontally or vertically. This creates a groove between the cover and my phone case where dust and grit collects, which ultimately forced me to go with a different vendor.

I have been a big fan of the Sony Experia phones for quite some time - they are finally available again in the US - and had some difficulty finding screen protectors for my phone. These fit perfectly and have great finger transference to your phone's screen so that touch-sensitivity is extremely light (no more need to "poke" your phone to get it to do what you want!)

Does a good job at protecting screen, but application process sucks and is incredibly frustrating. The stickers to hold the screen protector during application process are weak and do not hold the protector as you make adjustments.

I've tried two other screen protectors for my Xperia 5 III, and neither fit since they were a touch too large for the Xperia's slightly curved screen. This led to dust getting trapped, problems with my case, and the way proximity sensor being blocked.Mr. Shield is the first brand that fits properly! It's slightly smaller than the screen, which is a good thing for phones with slightly curved edges which makes full coverage an impossibility. It's also easy to install and a bargain. I also think it's full glue (but not 100% on that yet), which hopefully means I won't get glue spots showing in a few days (will update review of it does happen, though).If you're looking for a case-compatible screen protector for your 5 III, this should do the trick!

Installation was easy. Totally non-conductive. Screen was unresponsive with the shield on. De-installation and disposal was also easy. So they got that right

Everyone seems to complain because it doesn't touch edge to edge but I find with a good case and this glass protector it should give you 98% phone coverage. The reason they don't cover the complete screen is because if you use a case it will push against it and cause the glass to bubble as it is rounded on edges. That will make it more susceptible to breaking. Usually phone cases have a lip that covers edges of phones. I find you could make it better by adding a plastic screen protector on top of glass because if it does break from a drop the plastic will hold the glass pieces in place. Otherwise you will have little shards all over and it will be better to remove it if you want to use it immediately and you can't immediately replace it with another screen protector.

Le quedó bien

Pretty good. I like that they included the dust stickers, and while I don't believe the included cloth was a microfiber cloth, everybody has one or more kicking around these days. The screen protector fits the dimensions of the phone pretty exactly, so you do need to be pretty much perfect when applying it. I've gone though a few screen protectors so far, and they all have this issue, likely due the the design of the phone. My last one suffered from newton rings, but that doesn't seem to be a problem with these, since they use adhesive on the entire inside surface of the screen protector, so there is no tiny gap between the protector and the screen. The surface feels pretty good, and the image is is perfectly clear, with touch input and everything working fine. No complaints here.

This screen protector does not fit at all see the photos. There are massive gaps in the bottom and top. This cost almost $30 CAD which is unacceptable

Muy buen producto y trae todo lo necesario para colocarlo