Hiorucet WHF100 Blower Fan for Dyna-glo Heater 30,000 BTU, Mr. Heater and Comfort Glow Vent Free Heaters, Replacement WHF 100 Ventless Wall Mount Heater Fan Accessory Kit.

The product works way better than my old one. The warm air it pushes out is terrific. My old one made a lot of noise but didn’t heat my area up near as much as this one does. It was well packed, instructions were a little vague because it didn’t explain that you had to bolt the temp unit in for the fan to work correctly. Having one before I knew it had to be done. For some one not familiar with the unit they may not understand. Other than that very good unit.

A lot of people claim that they don't work good. Be realistic in your expectations! Works as it should to just move the air better. Not a lot of cfms there nor a lot of btus with the heater so don't expect more than it is. Happy with the performance and how the thermostat works on it! Would definitely do it all over again!

The fan does a great job in pushing out the heat from this heater in my 35' x 26' metal shop. Just make sure the back of the fan is not obstructed from getting air.

works good

My fan motor spins in reverse I assume the wiring is backwards

It was easy to install, despite the directions being very poor. It works well.

Easy set up and heats fast and well!

I installed this as I replaced my old heater with a Mr. Heater that came without a fan. The fan has no power to push the air into the room. Compared to the last heater I had with a fan this unit is pathetic.