Magnet Paint Co Chassis Saver - Gloss Black - MPC-UCP99-04 (Quarts)

Great product, works really well and looks even better. If you want a new car look on something that has aged this is the perfect product for the job.

Amazing product! Dried quick and had glossy finish. I’m converting a school bus to a camper, it really helps saving the rusty floor.

So very happy with this product second time buying it

I am very happy with the outcome of using this. Just a word of caution though WEAR GLOVES! This stuff is extremely difficult to get off of your skin! I tried every solvent known to man and nothing worked! Pure acetone was the only thing that had any affect at all and it took so long to start breaking up the paint on my hands that it was starting to take the skin off too! Other than that I would strongly recommend this product. It looks great when it's done and should last a long time

Very good product, wish i did not reduce by 10% and Do NOT use undercoating gun , the regular paint gun is much better. Using undercoating gun there is a lot of waste, too much material comes out and caused runs. Material is thin enough in my estimation not to need the S8 reducer. Was very happy with how it dries hard realatively quick. Overnight it was transformed to hard shell surface coat and not easily removed. Recomend blanketing area as it again disperesed too much material at a time. Ofcourse wear protective gear and mask.

Used this to coat the rusty frame of my trailer prior to a coating of HERCULINER. Used alone it looked great, but was advised it would face if uncoated and exposed to sun

I have used Chassis saver for many years and in my opinion, there is nothing better. This stuff sticks to pretty much everything. All you have to do is clean off dirt and loose rust and you are good to go. It is a relatively slow curing paint, so it will smooth itself some if painted on with a brush, or you can thin it out and spray with a spray gun. (I would not use your good quality gun though). Now for the Caveats: - There is no UV protection, so it will turn a gray color after it has been exposed to the sun for a while. This is not a real problem as you can rattle can paint over the top and avoid this. - If you open the can, make sure you thoroughly clean the surfaces of the lid and the top of the can, then cover the top of the can with plastic before putting the lid back on. If you fail to do this, you will never get the lid back off of the can. - it doesn't really work well on bare metal. You are better to prime your surface before using this. - If you get this on your skin, it will stay there for the next week or so. This stuff really sticks to anything it contacts. These are very minor things to tolerate for a product that coats and protects metal extremely well

We use this on the frames and floorboards of classic cars. It’s like iron! Can’t chip it off when pounding with a hammer.