⚡ Protect Your Power, Elevate Your Game!
The Circuit Breaker Reset Fuse 60A is engineered to protect your electrical systems from damaging power surges. Compatible with both 12V and 24V systems, it features a unique push button reset that also functions as a kill switch, ensuring your trolling motor and amps remain safe and operational. With robust 8GA inputs and a compact design, this fuse is a must-have for any serious boater or electrical enthusiast.
S**Y
Trips early
I have used it for a few months now and noticed it gets hot and trips early. I purchased the 200A version. I think the product is not made for continuous duty or even 80% of rating at continuous duty as that is what most breakers are rated at. I am probably not using it as intended maybe? I have it connected to a 12V inverter through two deep cycle 6V batteries in series and using it as overcurrent protection. I had a load on it for about 30 minutes pulling approximately 100A at 12V. The backside of the breaker got really hot and tripped in about 45 minutes. This might be good for startup loads reaching close to 200A but it won’t handle a continuous load even at half of the rating. Installation was easy. Judging by appearance of the housing, doesn’t appear waterproof.
K**T
It works!
Have bought at least 6 of these. All work great. I use them I. My boat and camper for power cut offs, bonus circuit breaker.
S**A
Make sure to check the voltage you are using it with.
I bought this thinking a breaker is a breaker, and current simply trips it independent of voltage.I was using it between my solar panels and controller. The panels put out about 100 VDC, and 54A max. This breaker worked most of the time, but twice it tripped when the current from the panels was near max. At first I blamed the breaker, but then saw that it is rated for 12 - 24 VDC. So I'm assuming it tripped early because I was using too high of a voltage.Overall I like it, easy to connect, mounts to a wall nicely, easy to reset. I will keep it for a future 12V project...
L**
Works for 4ga mostly fine
It was quite a task getting this to work for 4ga wife, but I got it eventually. Just be patient with it if your using 4ga, and put the plastic cover on your wire FIRST then put the ring on and screw it into the wire slot, then squish it down with the ring and plastic case.
C**S
Kept tripping way below its rated capacity.
This unit seemed good at first until I tested it. When using it the circuit breaker kept tripping at under 80 amps, even though it's rated for 200 amps. Also, the shrink tubes on the eye lugs were all extending into the contact area and had to be trimmed before installing in order to get the full contact surface. This is a novice error and an indication of poor quality control in the production.
A**O
Upgrades
Great start for a new edition to my vehicle
B**N
No directions in box and device has no power/load markings. No
It would be nice if it had markings of which end is power and the other end load Even a diagra3 sheet with it on it.
R**E
Great amp fuse
Like how easy it is to install and like how you can turn it off when working on wires.
Trustpilot
1 month ago
2 weeks ago