Lamp Shade Material DIY Adhesive Styrene Sheet Used to Make Lampshade Pre-Cut Length -14"High X 64"Wide. (White)

Somewhat difficult to work with, but did the job for my new lampshades.

Product was great, my expertise was not, Lol!

It’s a white lampshade base and yes comes rolled so you will have to train it back to flat to work with it easier. I weighed it down with heavy books for a couple of days while I gathered all my materials. Sticks to linen well, and a bit forgiving to make some adjustments while attaching. That said, I don’t think I can use it again. The 19” roll came with enough for two Med to large shades. That’s about 20 each, so pretty decent value. This is my first attempt in construction. It’s a odd shape, so I will definitely just do the bottom first, then top and adjust. In any case, this does exactly what it was meant to do.

Would not stay stuck. Looked cheap and hard to use

Wow, I did not know you could replace the firm plastic inner lining of a perfect lamp shade until now. So easy and beautiful.

So I watched the video and decided to use this product. I had purchased the fabric for bell shaped lampshade before I bought the sticky styrene.. The included instructions were confusing. (I have been sewing and going crafts for homes etc for 45 to 50 yrs.) . So , I knew where to make adjustments in the instructions. In addition, I bought 2 sided clear narrow extra adhesive tape to use on the fabric edge (fabric had been applid to the sticky styrene) to stick to the metal lamp shade. The edges of the sticky styrene did not stick WELL to the end pieces . So, i used a lot of small clips applied to the edges as we rolled the rim onto the styrene. Also, it took 4 hands to do the rolling/attaching of styrene to the rim/metal lampshade. .. I believe it would have been simpler if the lampshade had been a straight, cylinder shape as opposed to a bell shape. I used the double sided tape to seal/finish the point where 2 edges formed a "seam".

The adhesive is good, works great with linen fabric! If that was the only thing to this product, I’d rank higher. I purchased 2 rolls and regrettably, halfway through geach roll the paper backing stopped peeling off, leaving a layer stuck to the styrene. Had to use tweezers and a scraper to get it off, which left lines in the plastic that show when the light is on. Big-expensive bummer!

Worked awesome

Moyen, ne colle pas beaucoup et veut toujours rouler sur lui même

Completed the lampshade and within days the fabric (100% cotton) has detached from the product and will not reattach. I’m so disappointed as the initial lampshade looked great. Followed the instructions. Used the appropriate double sided tape. Placed weight on the area so see if it would reattach. It will not stick anymore. Very disappointed as this product was expensive.